advertisement
2.5 parent unit battery installation
You can power up the parent unit by connecting it to AC power or to the rechargeable battery provided. Even if the parent unit is connected to
AC power, we recommend you also install the battery. This guarantees continual operation in case of a power outage.
Install the battery as shown below.
1.
With the label THIS SIDE Up facing up, insert the small tabs of the battery into the slots inside the battery compartment. Make sure the metallic contact is correctly oriented as shown below. Push the battery into the battery compartment until it clicks securely into place.
Metallic contact
2.
Align the battery compartment cover flat against the battery compartment, then slide it t owards the center of the parent unit until it clicks into place.
12
3.
To replace the battery, press down on the large tab of the battery and pull it out of the battery compartment, then follow the steps on
12 to install the battery.
•
•
Notes
The operating time for using the rechargeable battery is short. If you want to monitor your baby for a long time, we recommend you connect the parent unit to AC power.
If the parent unit will not be used for a long time, disconnect and remove the battery to prevent possible leakage.
13
advertisement