advertisement
FS-250 Installation and Operation Manual
Serial Interface Circuit
The serial interface circuit can address up to 16 standard annunciators and/or 8 remote processors to drive graphic annunciation or relay modules. Devices on the circuit may be connected up to 4000 feet from the control panel. At the top of the main board, the terminal blocks are used for the connection of remote serial devices.
Serial Interface Circuit,
(=, -) 24VDC nominal, 0.4 max
(X+, X-) RS-485 levels
Wire Type-Twisted Pair For Data
Wire Resistance-11 ohms/line (4000’ max)
Supervised, Power Limited,
See Owner’s Manual for
Compatible Devices.
• Remote Device Power - When connecting devices on the serial interface circuit, a limited amount of current is available from the control panel. If more current supply is required for the connected devices, auxiliary power must be provided to each insufficiently powered device. Each address on the circuit must be fully powered from either control panel or auxiliary power (no combined source can be configured).
Technical Manuals Online! - http://www.tech-man.com
34
advertisement
Related manuals
advertisement
Table of contents
- 9 Power Supply
- 10 P2 Addressable Device Circuit
- 10 Notification Appliance Circuits
- 10 Serial Interface Circuit
- 10 Status Relays
- 10 Programming Port
- 10 FS-MT Municipal Tie Board
- 10 FS-DACT Board
- 10 FS-NPE Transformer Assembly
- 11 Battery Sets
- 11 Serial LCD Annunciator
- 11 Serial Relay Unit and Serial Relay Extender
- 11 Serial Annunciator Unit and Serial Annunciator Extender
- 11 PAD-3 Remote Signal Expander
- 12 FirePrint™ Smoke Detector
- 12 Heat Detectors
- 12 Addressable Modules (Monitor and Control)
- 12 Manual Stations
- 12 Programming P2 devices
- 14 Environmental
- 14 Power Limiting
- 14 Ground Fault Detection
- 14 NAC Operation
- 14 Transient Protection
- 14 Security Features
- 15 Federal Communications Commission
- 15 Underwriters Laboratories
- 15 Environmental
- 15 Primary Supply
- 15 Secondary and Trouble Power Supply
- 15 Auxiliary Power Outputs
- 16 Status Relays
- 16 Notification Appliance Circuits
- 16 Serial Interface Circuit
- 16 P2 Addressable Device Circuits
- 17 Municipal Tie (Optional Municipal Tie Board FS-MT)
- 17 DACT Circuit (Optional DACT Board FS-DACT)
- 18 Standby Condition
- 18 Alarm Conditions
- 19 Trouble Conditions
- 20 Supervisory Conditions
- 20 Maintenance
- 20 Lamp Test
- 20 Drill
- 21 Recall
- 21 Pre-Alarm
- 21 General Alarm
- 21 Alert
- 22 History
- 25 With Enclosure Packages (Black or Red)
- 25 With Electronics Package
- 25 With FS-NPE Transformer Package
- 27 FS-250 Enclosure Mounting Pictures
- 28 Remove Knock-Outs
- 28 Main Board Installation
- 29 Transformer Mounting – FS-NPE
- 30 FS-DLC Loop Driver Board Mounting
- 30 Door Assembly
- 31 Display Board Installation
- 32 Front Plate Mounting
- 33 Ground Wire Installation – P/N
- 33 AC Supply Connection
- 34 Battery Installation
- 34 Powering The Control Panel
- 34 Optional Modules
- 34 Check System Operation
- 35 Control Panel Wiring Overview
- 35 Wiring Entering Enclosure
- 35 Install Wiring
- 36 Wiring Separation
- 37 Primary And Secondary Power Wiring
- 38 Status Relays And Auxiliary Power Outputs Wiring
- 38 FS-250 System Power Requirements (Does not include NAC power)
- 39 Auxiliary Power Supply
- 39 Battery Size Calculations
- 39 NAC Wiring
- 40 Serial Interface Circuit
- 41 Serial Remote Device Wiring Overview
- 41 P2 Addressable Device Circuit(s)
- 42 P2 Addressable Device Wiring Diagrams
- 47 Resistance of Solid Copper Wire
- 47 Notification Appliance Circuit Wire Selection Guide
- 47 Maximum Wire Loop Distance (Feet)
- 48 Addressable Device Circuit Wire Selection Guide
- 48 Line Resistance Graph
- 49 FS-250 Current Calculations
- 49 Auxiliary Module Battery Calculations
- 50 Device Current Calculations
- 51 Total System Currents
- 51 Battery Size
- 52 Siemens P2 Manual Pull Stations
- 52 Siemens P2 Modules
- 52 Siemens P2 Photo Electric Detectors
- 52 Siemens P2 Bases
- 52 Siemens P2 Accessories
- 53 Notification Appliances
- 62 A. General
- 63 B. System Troubles
- 64 C. System Events