• Switching LOCAL/REMOTE Modes
The following functions can be selected by switching the LOCAL or REMOTE mode. To select RUN/STOP commands or frequency reference, change the mode in advance depending on the following applications.
• LOCAL Mode:
Enables the digital operator for RUN/STOP commands and
FWD/REV run commands. Frequency reference can be set by
volume or
• REMOTE Mode:
.
Run by the n02 setting (operation reference selection).
Frequency reference can be set by n03 (frequency reference selection) setting.
• How to select LOCAL/REMOTE modes
(When 17 is not set to any parameters n36 to n39)
(When 17 is set to any parameters n36 to n39)
61
