Selecting Run/Stop Commands. YASKAWA VS mini CIMR-J7B0P7, VS mini CIMR-J7B0P1, VS mini CIMR-J723P7, VS MINI J7, VS mini CIMR-J720P2, VS mini CIMR-J722P2, VS mini CIMR-J720P4, VS mini CIMR-J7AU20P1, VS mini CIMR-J7B0P4, VS mini CIMR-J721P5

• Selecting Run/Stop Commands

Refer to page 63 to select either the LOCAL mode or REMOTE mode.

Operation method (RUN / STOP commands, FWD / REV run commands) can be selected by the following method.

• LOCAL Mode

When Lo (local mode) is displayed on the digital operator (when is illuminated), or when the LOCAL / REMOTE changeover function is set as a multi-function input and the input terminal is turned ON, run operation is enabled by the or of the digital operator. FWD/REV is selected by illuminating and using or key to select FWD or REV.

• REMOTE mode

• Select remote mode

The following two methods are used to select remote mode:

1. Select rE (remote mode) for selection.

2. When the local / remote switching function is selected as multi-function input selection, turn OFF the input terminal to select remote mode.

• Select operation method by setting the parameter n02.

n02=0: Enables the digital operator (same with local mode)

=1: Enables the multi-function input terminal (see fig. below)

=2: Enables communications (refer to page 96)

• Example for using the multi-function input terminal as operation reference

(two-wire sequence) follows. For 3-wire sequencing, refer to page 85.

• Operating (RUN /STOP commands) by communications

(When option card is installed)

Setting parameter n02 to 2 in REMOTE mode can give RUN / STOP commands by communication (MEMOBUS). For details, refer to page 96.

62