Walking Belt Electrostatic Reduction. Bowflex TC5, BowFlex TC5, TreadClimber TC5

Maintenance

Walking Belt Electrostatic Reduction

Your TreadClimber ® machine may develop a static charge caused by the movement of the walking belts. Follow this procedure to apply an anti-static spray to them to reduce the static electric charges.

Wait a minimum of 60 minutes after the last workout before you apply the anti-static spray, to let hot electrical components cool to room temperature.

1. Remove the batteries from the Console.

2. Carefully apply the anti-static spray to lightly cover the top surface of the walking belts along the front of the machine (green highlighted area).

NOTICE: Hold the spray dispenser approximately 6” (13 cm) above the walking belt and point the spray

toward the front of the machine. Apply the spray only on the belts, not on the deck or mechanism.

If spray goes off the belts, wipe the excess spray off the other parts of the machine.

Note: Be sure to obey the manufacturer safety instructions for the anti-static product.

machine, exposing the next unsprayed section.

anti-static spray.

7. Install the batteries into the Console.

Note: Repeat the procedure to apply anti- static spray if static electric discharge occurs again. The machine will accumulate more static electric charge when the sur- rounding air is drier. Be sure to obey the manufacturer safety instructions for the anti- static product.

Maintenance

Maintenance Parts

Console / Handlebar Assembly

Flywheel and Speed Sensor Magnet

Right Junction Cover

Left Junction

Cover

Left Upright

Right Upright

Front Cover

Left Side

Cover

Rear Cover

Right Side

Cover

Treadle Assembly

30

Maintenance

Maintenance Parts (Treadle Assembly)

Walking Belt Adjustment

Screw

Walking Belt Guide

Heim Joint and One Way

Bearing

Dependency

Bumper

Side Foot

Support Platform

Dependency

Walking Belt Adjustment

Bracket

Front Roller

Lower Walking Belt Guide

Drive Chain

Belt Tensioner

Drive Belt

Speed Sensor

Rear Roller

31