7.1.6 FASTEN JUNCTION BOX. Blomberg Dishwasher

7.1.6. FASTEN JUNCTION BOX

1. Pull the wires into the junction box. Be sure that the wire nuts do not loosen.

2. Replace the cover on the junction box.

3. Secure the cover with the screws (Figure D).

Figure D

Ø

1/8

" (3,5mm)

Ø

1/8

" (3,5mm)

7.2 READJUSTING FOOT LEVELS

Now that the dishwasher is in the cabinet you must readjust the feet to bring the dishwasher up to the required height and attach it underneath the countertop.

1. Readjust the front foot levels with adjusting wrench to balance the dishwasher and raise it up under the countertop, make sure the unit is level.

2. Readjust the rear foot levels with a screwdriver to balance the dishwasher and raise it to the required height using the brackets supplied.

3. Attach the dishwasher underneath the countertop with the four screws supplied (Ø 1 /

8

" x 5 /

8

" - Ø 3.5 mm x 14 mm). Make sure you do not go through the top of the countertop or damage granite.

15