advertisement
Ý Notice :
The installer is responsible for the dishwasher installation. Incorrect installation is not covered by the warranty.
8. INSTALLER CHECKLIST
Your installer must have completed and checked the following:
= The dishwasher is square and level.
=
=
=
=
=
=
=
The dishwasher is fastened securely to the cabinetry.
The dishwasher door opens and closes freely.
The dishwasher door must close without hitting any cabinetry or counter top.
The inlet water supply is turned on and checked for leaks.
The drain hose has been connected and checked for leaks. There must be no kinks or obstructions in the drain hose.
The drain hose must be installed with a 28" (710 mm) high drain loop for drain hook-ups without any air removed.
If the dishwasher drain is hooked up to a garbage disposal, the drain hopper plug must be removed.
The spray arms are free and rotate freely.
=
=
=
The rinse cycle has been run.
The water level will be below the filter screen after the end of the wash program. It is normal to find some water in the drain filter area.
Set the water softener to the correct water hardness for your area. If the dishwasher drain is connected to a garbage disposal, make sure that the drain/hopper plug has been removed.
Ý Notice :
If the dishwasher does not operate properly, refer to the self help hints.
10. SELF HELP HINTS:
=
=
The power indicator light doesnt come on:
Check to make sure the breaker to the dishwasher is in the on position.
Check all the wire connections in the junction box are tight and not loose.
=
=
=
No Water is coming into the dishwasher:
Check to make sure the hot water shut-off is in the
ON position.
Water does not drain:
Make sure drain hose is not kinked or comes out of air gap next to the sink.
Remove drain hose from disposal making sure plug is removed.
=
Ý
=
Notice :
If your dishwasher is not operating properly after following these steps: Contact your dealer to schedule an authorized service agent to inspect your new dishwasher for any function related failure.
The manufacturer warranty does not cover installation or customer education service visits.
DWT xxxxx xxxxx
9. FINAL INSTRUCTIONS
1. Press the On/Off button to turn the dishwasher on.
2. Power indicator light comes on.
3. Use the Cycle Select button to choose a washing program.
4. Start the program with the Start/Pause button.
5. Run the dishwasher through one complete cycle.
When the progress indicator light End lights up, the wash cycle is completed. Use the On/Off button to turn the dishwasher off.
You will find the model and serial number information on the label located on the right-hand side of the inner door of your dishwasher, as shown above.
Ý Notice :
Please make a copy of your invoice and keep it with this manual and register your dishwasher on-line.
Installation Manual-USA
23
17 1156 01 00-00
USA
advertisement
Related manuals
advertisement