INSTRUCTIONS FOR REPLACING THE DOOR
1. Remove the profile frame
2. Disconnect both of the connection sockets
3. Remove the display housing
4. Remove the door's profile frame including the lighting cable
MT-01 Indice 0 Page 69
5. Cut off the socket at the end of the cable
6. Remove the cable fittings
7. Remove the cable from the door
MT-01 Indice 0 Page 70
8. Remove the pivot from the upper hinge using a flatheaded screwdriver
9. Gently tilt the top of the door and lift as illustrated on the photograph
10. Place the two plastic guards in the hole for the upper hinge of the new door
11. Install the new door and attach using threaded rods
MT-01 Indice 0 Page 71
12. Insert the cable in the door and attach using plastic clamps as illustrated on the photograph
13. Prepare the end of the cable and install the wires in the socket; order of the colours: yellow, green, brown, and white
14. Push the four metal connections on the socket using a thin screwdriver
MT-01 Indice 0 Page 72
15. Place the profile frame next to the door and take the display housing
16. Reconnect both of the sockets to the display housing
17. Replace the display housing in the frame of the door and attach with four screws
18. Push the profile frame into the door. Start with the internal corners and continue along the sides of the frame.
MT-01 Indice 0 Page 73
