INSTRUCTIONS FOR REPLACING SENSORS
1. Remove the label stuck to the sensor
2. Remove the paste from the pipe inlet
MT-01 Indice 0 Page 77
3. Remove the sensor from the pipe
4. Detach the sensor cable from its fittings
MT-01 Indice 0 Page 78
MT-01 Indice 0
5. Remove the screws from the housing cover
6. Remove the screws from the switch box
Page 79
The shortest cable on the switch box can limit access to the sensor sockets.
If there is too much play in the door, the connection cable can be pulled out by 20/30cm through the pipe located at the back of the cabinet
MT-01 Indice 0 Page 80
7. Disconnect the sensor sockets from the electronic card
MT-01 Indice 0 Page 81
8. Connect the sockets on the new sensors to the switch box
S_RH: humidity sensor
S_P1: lower temperature sensor
S_P2: upper temperature sensor (only in multi-temperature cabinet)
COM: connection cable (display housing)
MT-01 Indice 0 Page 82
MT-01 Indice 0
9. Replace the switch box fixing screws
10. Replace the box cover and fix in place using the screws
Page 83
11. Insert the sensor approx. 30 cm into the pipe until the sensors come to a stop
12. Reseal the end of the pipe using paste, which shall initially remain uncovered
13. Affix the silver label to cover up the paste
14. Attach the sensor cable using the fixing elements
MT-01 Indice 0 Page 84
