Alarm message „E. Electrolux EHF8748FOK

5.3

Alarm message „E“

When the appliance is switched on, „E“ / „xx“ Alarm Number is displayed in the timer display.

The affected zones are subsequently displayed with an „E“ in the cooking phase display and are thereby disabed. The other zones can still be used.

Example:

1) Error code 8 for the left board

Alarm

Symptom

Display in the Cooking

Hob Timer

"E2“ Alarm display in the Touch

Control.

"E3“

Possible Alarm

Cause

User interface temperature too high

400 VAC detected, instead of 230VAC, on left or right module or both

"E4“

"E5“

Alarm Remedying

Temperature too high due to installation, or UI defect.

Coil temperature sensor defect, not correctly connected, or broken, display in the corresponding zone.

Coil temperature sensor defect, short, display in the corresponding zone.

1) verify power lines connection, on the wall

2) Should alarm still be displayed, verify internal connection in the hob,

3) Should alarm still be displayed, See Chapter Testing

Power Component

1) Inspecting the contacts on the power board. Is the connector inserted?

2) The resistance at room temperature (25°C) amounts to

100 kOhm. If not in this range, replace affected temperature sensor.

3) Should above not succeed, replace power component concerned.

1) Inspecting the contacts on the power board.

2) The resistance at room temperature (25°C) amounts to

100 kOhm.If not in this range, replace affected temperature sensor.

3) Should above not succeed, replace power component concerned.

DGS-TDS-N 02.06 U. H. / A. B. © Electrolux - 14 599 525 284 EN