B. Using the 35mm Filmstrip Template. Microtek ScanMaker 9800XL Plus

B. Using the 35mm Filmstrip Template

To scan 35mm filmstrips, use the 35mm Filmstrip Template, which can simultaneously hold two strips of 6 frames each, or a total of 12 frames.

1. Place the 35mm filmstrip to be scanned inside the frame of the 35mm Filmstrip

Template. The shiny base of the 35mm filmstrip should be facing down, and the emulsion side of the filmstrip should be facing up.

Orient template with

"Microtek" logo facing up

Align the edge of the film frame with the arrow mark of the template

Calibration strip

Microtek logo

2. Place the 35mm Filmstrip Template containing the loaded filmstrip on the scanner glass surface. Make sure to orient the template with the “Microtek” logo facing up.

6

5

4

3

2

1

0

1

2

3

4

5

6

The Grabber is used to remove the template out of the scanner glass surface.

Important: Align the template's front corners firmly against the top corners (left and right) of the

U-shaped ruler located at the front of the scanner. During placement of the template, make sure that the calibration strip on the scanner glass surface is kept clear and free of obstruction at all times.

12 ScanMaker 9800XL Plus User Guide