Jumper Setting. EVOC EC7-1817LNAR

Chapter 2 Installation

Jumper Setting

1. JCC1: Clear/Keep CMOS Setting (Pitch: 2.54mm)

CMOS is powered by the button battery on board. Clearing CMOS will restore original settings (factory default). The steps are listed as follows: (1) Turn off the computer and unplug the power cable; (2) Instantly short circuit JCC1; (3) Turn on the computer; (4) Follow the prompt on screen to enter BIOS setup when booting the computer, load optimized defaults; (5) Save and exit. Please set as follows:

JCC1

Setup

1-2 Open

1-2 Short

Function

Normal (Default)

Clear the contents of CMOS and all BIOS settings will restore to factory default values.

2. JM1: Clear/Keep ME Register Setting (Pitch: 2.54mm)

JM1

Setup

1-2 Open

1-2 Short

Function

Normal (Default)

Clear the contents of ME RTC register and all the settings will restore to factory default values.

3. JP1: Enable the Operating Voltage of LVDS and Embedded Panel (Pitch:

2.54mm)

Setup

1-2 Short

Function

Enabled LVDS Voltage (Default)

JP1

2-3 Short Enabled EDP Voltage

4. JP2: SPI Flash Safety Performance Setting (Pitch: 2.54mm)

Setup Function

JP2

1-2 Open

1-2 Short

Enable ME function and disable on-line refresh

BIOS. (Default)

Disable ME function while enable on-line refresh

BIOS.

Note: when short circuit JP2 (1-2), ME is disabled; an error prompt of “The system doesn’t comply with the minimum requirement to install the software” will appear when installing the AMT driver; therefore, before installing the ME driver, please set the jumper cap of JP2 to “OFF” so as to enable ME.

- 8 - EC7-1817LNAR