1 SCPI Overview

RIGOL

4. Real

The parameter can be any real number within the effective value range and this command accepts decimal and scientific notation parameter input. For example,

:FUNCtion:WREPlay:INTerval <interval>

:FUNCtion:WREPlay:INTerval?

Wherein, <interval> can be set to any real number between 0.0000001 (or 1e-07, namely 100ns) to

10 (or 1e+01, namely 10s).

The query returns a real number in scientific notation.

5. ASCII String

The parameter should be the combinations of ASCII characters. For example,

:CALCulate:ADVanced:EXPRession <expression>

:CALCulate:ADVanced:EXPRession?

Wherein, <expression> can be set to CH1+CH2

The query returns an ASCII string.

Command Abbreviation

All the commands are case-insensitive and you can use any of them. If abbreviation is used, all the capital

English letters and numbers in the command must be written completely. For example,

:CALCulate:ADVanced:VARiable1? can be abbreviated to

:CALC:ADV:VAR1?

MSO2000A/DS2000A Programming Guide 1-3

2 Command System

RIGOL

2 Command System

This chapter introduces the command subsystems of MSO2000A/DS2000A command set.

The topics of this chapter:



:AUToscale



:CLEar



:RUN



:STOP



:SINGle



:TFORce



:TLHAlf



IEEE 488.2 Common Commands



:ACQuire Commands



:BUS<n> Commands



:CALCulate Commands



:CALibrate Commands



:CHANnel<n> Commands



:CURSor Commands



:DISPlay Commands



:FUNCtion Commands



:LA Commands (For MSO2000A/MSO2000A-S)



:LAN Commands



:MASK Commands



:MEASure Commands



:OUTPut<n> Commands (For MSO2000A-S/DS2000A-S)



:RECall Commands



:REFerence Commands



:SAVE Commands



:SOURce<n> Commands (For MSO2000A-S/DS2000A-S)



:SYSTem Commands



:TIMebase Commands



:TRACe<n> Commands (For MSO2000A-S/DS2000A-S)



:TRIGger Commands



:WAVeform Commands

Note:

1. Unless otherwise noted, the introductions and parameter ranges in this manual are based on

MSO2302A-S.

2. For parameter setting commands (such as time, frequency and amplitude), the oscilloscope can only accept numbers and set the parameters using the default units; it cannot recognize the units sent with the parameters. For the default unit of each parameter, please refer to the description in each command in the following introductions.

MSO2000A/DS2000A Programming Guide 2-1