Programming Preparations. Rigol DS2072A, DS2202A, DS2000A Series

RIGOL

Programming Preparations

Before programming, make the following preparations.

1. Install the Ultra Sigma common PC software. You can acquire the software from the resource CD in the standard accessories or download it from RIGOL official website (www.rigol.com). Then, follow the instructions to install the software. When Ultra Sigma is installed, NI-VISA library is installed automatically. In this manual, the default installation directory is C:\Program Files\IVI

Foundation\VISA.

2. In this manual, the USB Device interface of the oscilloscope is used to communicate with the PC.

Please connect the USB Device interface at the rear panel of the oscilloscope with the PC using a USB cable. You can also use the LAN or GPIB (with the USB-GPIB interface converter provided by RIGOL) interface to communicate with the PC.

3. After the oscilloscope is correctly connected to the PC, power on and start the oscilloscope.

4. At this point, the "Found New Hardware Wizard" dialog box appears on the PC. Please install “USB

Test and Measurement Device (IVI)” according to the instructions (for the installation method, refer to MSO2000A/DS2000A User’s Guide ).

5. Acquire the USB VISA descriptor of the oscilloscope. Start Ultra Sigma and the instrument resource found is displayed under the “RIGOL Online Resource” directory in the Ultra Sigma interface together with the instrument model and USB information. In this demo, the USB VISA descriptor of the oscilloscope used is USB0::0x1AB1::0x04B0::DS2A0000000000::INSTR.

By now, the programming preparations are finished. In the following part, detailed introductions are given about the programming demos in the Excel, Labview, Matlab, Visual Basic 6.0 and Visual C++ 6.0 development environments.

3-2 MSO2000A/DS2000A Programming Guide