advertisement
PID Display Is Turned Off
Alex Duetto 3.0 Espresso Machine
Make sure the main power switch is turned on and the outlet has power.
Make sure the water reservoir is filled with cold softened water.
If plumbed in make sure that the water supply is turned on to the machine.
Turn the machine off for 3 seconds and then turn back on to reset.
Steam Is Continually Discharged Into The Drip Tray
During heat up a small amount of steam will be discharged into the drip tray. The steam should stop within a few minutes after the boiler pressurizes. If the steam continues to fill the drip tray after a few minutes then the vacuum breaker valve should be replaced.
A replacement vacuum breaker valve can be found on our website at the link below. http://www.chriscoffee.com/products/home/isomacparts/vbreakervalve
Steam Gauge Shows Full Pressure But Drops To Zero When Steam Knob Is Opened
This is caused by a sticking vacuum breaker valve which causes the boiler to build air pressure instead of steam pressure. A replacement vacuum breaker valve can be found on our website at the link below. http://www.chriscoffee.com/products/home/isomacparts/vbreakervalve
Old Style Vacuum Breaker New Style Vacuum Breaker
23
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 3 Diagrams
- 4 Introduction
- 7 Before Each Use
- 8 Normal Operation
- 8 Reservoir
- 8 Audible Alert
- 9 Pressure Gauges
- 9 Lights
- 10 Switches
- 10 Drain Kit
- 11 PID Controller
- 11 Setting Temperature
- 12 Advanced Settings And Modes
- 13 Brewing Espresso
- 13 Quantity of ground coffee
- 13 Tamping
- 13 The grind
- 13 Consistency
- 13 Cleaning Tip
- 14 Milk Temperature
- 14 Frothing Pitcher
- 14 Amount of Milk
- 14 Stretching the milk
- 14 Texturizing the milk
- 15 Steaming Milk - Technique
- 16 Helpful Tips and Information
- 16 Hot Water Wand Operation
- 17 Regular Maintenance
- 17 Backflushing
- 17 Plain water backflushing
- 17 Backflushing with espresso machine cleaner
- 18 Removing The Outer Shell
- 18 Setting Pump (Brew) Pressure
- 19 Group Gasket And Shower Screen Replacement
- 19 Gasket and Screen Removal
- 20 Cleaning The Group
- 20 Gasket And Screen Installation
- 22 Descaling
- 22 Troubleshooting
- 22 No Steam From Steam Wand
- 23 No Water From Hot Water Wand
- 23 Not Heating
- 24 PID Display Is Turned Off
- 24 Steam Is Continually Discharged Into The Drip Tray
- 24 Steam Gauge Shows Full Pressure But Drops To Zero When Steam Knob Is Opened
- 25 Espresso Coming Out Too Slow Or Not At All
- 25 Espresso Coming Out Too Fast
- 25 Leaking Around Portafilter When Brewing
- 25 PID Alarm Codes
- 26 Warranty
- 26 We Are Here To Help