advertisement
Alex Duetto 3.0 Espresso Machine
Espresso Coming Out Too Slow Or Not At All
Activate the brew lever and check the pump pressure. Recommended setting is 9 bar.
Adjust pump pressure if necessary.
If pump pressure is good then try adjusting grind coarser.
Be sure the insert basket is not over filled with coffee and you are tamping with no more than 30lbs of pressure.
Espresso Coming Out Too Fast
Activate the brew lever and check the pump pressure. Recommended setting is 9 bar.
Adjust pump pressure if necessary.
If pump pressure is good then try adjusting grind finer.
Be sure the insert basket is filled with the proper amount of coffee and you are tamping with 30lbs of pressure.
Leaking Around Portafilter When Brewing
Make sure portafilter is tightly locked into the grouphead as far right as it can go.
Make sure the portafilter basket is not over filled with coffee.
Replace the group gasket if more than a year old.
PID Alarm Codes
A1 Channel 1 Unplugged
A2 Channel 1 Short Circuit
A3 Channel 2 Unplugged
A4 Channel 2 Short Circuit
A5 Channel 3 Unplugged
A6 Channel 3 Short Circuit
Check temperature sensor, heater connections, and reset for coffee boiler.
Check for damaged temperature sensor in coffee boiler.
Check temperature sensor, heater connections, and reset for steam boiler.
Check for damaged temperature sensor in steam boiler.
Check PID programming, reset to default settings.
Check PID programming, reset to default settings.
24
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 3 Diagrams
- 4 Introduction
- 7 Before Each Use
- 8 Normal Operation
- 8 Reservoir
- 8 Audible Alert
- 9 Pressure Gauges
- 9 Lights
- 10 Switches
- 10 Drain Kit
- 11 PID Controller
- 11 Setting Temperature
- 12 Advanced Settings And Modes
- 13 Brewing Espresso
- 13 Quantity of ground coffee
- 13 Tamping
- 13 The grind
- 13 Consistency
- 13 Cleaning Tip
- 14 Milk Temperature
- 14 Frothing Pitcher
- 14 Amount of Milk
- 14 Stretching the milk
- 14 Texturizing the milk
- 15 Steaming Milk - Technique
- 16 Helpful Tips and Information
- 16 Hot Water Wand Operation
- 17 Regular Maintenance
- 17 Backflushing
- 17 Plain water backflushing
- 17 Backflushing with espresso machine cleaner
- 18 Removing The Outer Shell
- 18 Setting Pump (Brew) Pressure
- 19 Group Gasket And Shower Screen Replacement
- 19 Gasket and Screen Removal
- 20 Cleaning The Group
- 20 Gasket And Screen Installation
- 22 Descaling
- 22 Troubleshooting
- 22 No Steam From Steam Wand
- 23 No Water From Hot Water Wand
- 23 Not Heating
- 24 PID Display Is Turned Off
- 24 Steam Is Continually Discharged Into The Drip Tray
- 24 Steam Gauge Shows Full Pressure But Drops To Zero When Steam Knob Is Opened
- 25 Espresso Coming Out Too Slow Or Not At All
- 25 Espresso Coming Out Too Fast
- 25 Leaking Around Portafilter When Brewing
- 25 PID Alarm Codes
- 26 Warranty
- 26 We Are Here To Help