Registering FIPS Code. Uniden Voyager, VOYAGER - VHF

VOYAGER.QX 11/19/2 2:19 PM Page 17

Registering FIPS Code

Six digit FIPS Codes are programmable in 15 channels, number 1~15 for NWR-SAME Weather Alert. If there is no data registered in location number 1, all of the signals are decoded. Contact the National Weather

Service at 1-888-NWR-SAME for the FIPS Codes in the area of interest, or visit http://www.nws.noaa.gov/nwr/indexnw.htm

1 Press and hold the MEM/FIPS key for 1.5 seconds.

2 Select the channel, numbers 1~15, you want to program using the

▲ or ▼ key.

3 Press the MEM/FIPS key to enter the

FIPS Code edit mode.

4 To enter the first digit of the code, change the left blinking digit on the display using the

▲ or ▼ key and press the MEM/FIPS key. The right digit starts to blink.

5 To enter the second digit of the code, change the right blinking digit on the display using the

▲ or ▼ key and press the MEM/FIPS key.

The entered digit moves to the left and the right digit starts to blink.

6 Repeat step 5 for the remaining digits of the code.

7 After the last digit registers, the entered code appears on the display automatically for confirmation.

8 To exit from this mode, press and hold the MEM/FIPS key for

1.5 seconds.

9 Press UIC to clear the stored FIPS Code in the displayed location.

• Pressing the MEM/FIPS key for more than 1.5 seconds in the middle of the above steps prevents registration.

17