Installer and ser vice menu (I/S). Bosch EHP 6-17 LW, EHP 6-11 LW, EHP 6-11 LM

Commissioning the heat pump

Installer and service menu (I/S)

As the installer you have your own section of menus for settings, e.g. for commissioning. These are accessed from the control panel by holding down the menu button for approximately ten seconds.

The menu displays are divided into lines and each display has a number to make it easy to fi nd. If there is no activity for 30 minutes the menu display automatically returns to Customer level 1.

The Installer level also includes Customer levels 1 and 2.

How to use the control panel

Here follows an example of how to use the control panel. The example shows how you move to menu display 5.13 and confi rm the external sensors. You will also fi nd more information about the control panel under the heading Control Panel in the

User section.

1. Press the menu button for approximately ten seconds until Access = SERVICE is shown on the menu display. Now press the Menu button.

Warning

The Installer and service menu (I/S) is only for installers. Under no circumstances may the user access this level.

Reg 637 I/S

040622 16:08:15 Tu

temp. Info Menu

2. The menu display Indoor temperature settings (menu 1) is shown.

3. Turn the menu dial clockwise (to the right) until you access the menu

Commiss./Service for installer (menu 5). Now press the Select button.

4. Turn the menu dial clockwise until you reach the menu Connected extra sensor in op.

(menu 5.13). Now press the Select button.

5. The menu display Extra sensor(s) is shown. Confi rm the extra sensors that you have connected by pressing the Confi rm button.

text is briefl y shown in the menu display. This means your setting is being registered in the heat pump.

Main menu

Indoor temperature settings 1

Return Select

(10 sec)

Main menu

Commiss./Service for installers 5

Return Select

Commiss./Service

Connected extra sensor in op 5.13

Return Select

Extra sensor(s)

GT4 GT5

Return Confi rm

Extra sensor(s)

Confi rming…

7. When the setting has been registered the previous menu display is shown.

Press the Return button twice to return to the main menu.

Extra sensor(s)

GT4 GT5

Return Confi rm

65