9. Safety Operation Guide. PTN MHD44TP

HDBaseT Matrix Switchers 4x4

9. Safety Operation Guide

In order to guarantee the reliable operation of the equipments and safety of the staff, please abide by the following proceeding in installation, using and maintenance:

1) The system must be earthed properly. Do not use two blades plugs and ensure the alternating power supply ranged from 100v to 240v and from 50Hz to 60Hz.

2) Do not put the switcher in a place of too hot or too cold.

3) As the power generating heat when running, the working environment should be maintained fine ventilation, in case of damage caused by overheat.

4) Cut off the general power switch in humid weather or left unused for long time.

5) Before following operation, ensure that the alternating current wire is pull out of the power supply:

 Take off or reship any components of the equipment.

 Take off or rejoin any pin or other link of the equipment.

6) As to non-professional or without permission, please DO NOT try to open the casing of the equipment, DO NOT repair it on your own, in case of accident or increasing the damage of the equipment.

7) DO NOT splash any chemistry substance or liquid in the equipment or around.

PTN Electronics Limited 16 www.PTN-electronics.com