Electrical Requirements. Wolf SO30F/S, DO30U/B, SO30U/P, DO30U/S L Series, SO36U/B, Wall Ovens, DO30U/P, SO36U/S, SO30U/B, SO36U

Component Access and Removal

W allll O ve s

Glass Pack Removal

NOTE: There are different screws sizes. Make sure the proper length screws are in the correct places when reassembling.

To begin, remove oven door assembly and outer door skin assembly. Now, extract the screw at the bottom center of the door liner. Next, extract the seven screws at the top of the heat shield and remove. (See Figure

4-39). Now, carefully remove insulation from around glass pack. Then, extract the screws from the top of the inner heat shield and remove. (See Figure 4-40).

Now, lift the top of the glass pack up slightly while pulling it out from under the bottom tabs and remove.

(See Figure 4-41).

Figure 4-40. Removing Inner Heat Shield.

When removing or disconnecting the door hinge, remember it could recoil quickly when released.

Hinge Removal

To begin, remove the oven door assembly and outer door skin assembly. Next, extract the two screws at the bottom corner of the door liner. (See Figure 4-42).

Raise the bottom of the door hinge assembly from the door liner. Then, using a small flat bladed screwdriver, carefully raise the tab at the top of the hinge and slide the hinge out from under tab and remove. (See Figure

4-43).

Hydraulic Hinge Removal

To begin, remove the oven door assembly and outer door skin assembly. Next, extract the two screws at the bottom corner of the door liner. (See Figure 4-42).

Now, raise the bottom of the hydraulic hinge assembly from the door liner. Then, using a small flat bladed screwdriver carefully raise the tab at the top of the hydraulic hinge and slide the hinge out from under tab and remove. (See Figure 4-43).

Figure 4-41. Removing Glass Pack Assembly.

Figure 4-42. Extracting Screws for Hinge Removal.

Figure 4-39. Extracting Screws from Heat Shield.

4-14

Figure 4-43. Raising Tab for Hinge Removal.