Configuration (DMX). Chauvet COLORado 1 tour

Operation

Configuration Use DMX configurations to operate the product with a DMX controller.

(DMX)

DMX

Personalities

This setting allows you to choose a particular DMX personality.

1. Go to the PERS main level.

2. Select the desired personality (TOUR, TR16, STD.Y, FULL, C1Q, ARC.1, AR1.D, ARC.2,

AR2.D, AR2.S, AR2.Z, or HSV).

· See the DMX Values section for the highest starting address you can select for each personality.

· Make sure that the starting addresses on the various products do not overlap due to the new personality setting.

DMX Control In this mode, each product will respond to a unique starting address from the DMX controller. All products with the same starting address will respond in unison.

1. Select a DMX personality as shown in DMX Personalities .

2. Set the running mode: a. Go to the RUN main level. b. Select the DMX programming level.

3. Set the starting address: a. Go to ADDR main level. b. Select the starting address (001–512).

The highest recommended starting address for each DMX mode is as follows:

DMX

Personality

DMX

Address

DMX

Personality

DMX

Address

DMX

Personality

DMX

Address

TOUR

ARC.1

AR1.D

FULL

501

510

509

488

ARC.2

AR2.D

AR2.S

C1Q

509

508

507

503

HSV

TR16

STD.Y

AR2.Z

510

496

496

506

Loss Of Signal

Setting

This setting controls how the product will respond when the DMX signal is lost.

1. Go to the SET main level.

2. Select DERR. a. Select SAVE to make the product use the last command used when the signal is lost. b. Select BLAK to turn off the all the LEDs when the signal is lost.

Zoom Limit

Settings

These settings allow you to select the zoom range. Basic zoom (BASE) is the default setting which allows the zoom to move at full range (000–255) and has no adjustable limit. Position 1

(POS.1) and Position 2 (POS.2) allow you to set limits on how far the zoom moves.

1. Set the zoom range to be used: a. Go to the SET main level. b. Select ZOOM. c. Select BASE, POS.1, or POS.2.

2. Set the limit for zoom range POS.1 or POS.2: a. Go to the ZOOM main level. b. Select POS.1 or POS.2. c. Select a zoom limit value (P.000–255).

Colorado™ 1-Quad Zoom Tour User Manual Rev. 1 -15-