advertisement
▼
Scroll to page 2
of
71
4.1
Message Center Operations
Communicating with another device on the I 2 C Bus is easy. Just install the software as described in Section 3, then following these simple steps:
4.1.1 Starting the Message Center
Click, Start
*
Programs
* iPort Utility Pack
* iPort Message Center
4.1.2 Selecting the Adapter
Select the I 2 C adapter you are using by clicking the corresponding adapter image
(see Opening Screen), or the Device Select checkbox (see Main Application
Screen).
Opening Screen
Main Application
17
advertisement
Related manuals
advertisement
Table of contents
- 9 C Bus Host Adapter
- 10 1 Overview
- 10 C Bus Host Adapter
- 10 iPort Utility Pack Software
- 10 iPort/AFM Programmer’s Reference
- 11 Packing Slip
- 11 System Requirements
- 11 2 Interconnects
- 11 RS-232 Serial Port Connector
- 12 DB-25 Serial Port Pinout
- 12 DB-9 Serial Port Pinout
- 12 +5VDC Power Jack
- 12 C Interface Connector
- 13 Interrupt (/INT) Signal Connector
- 14 3 Hardware Configuration
- 14 Pull-up Resistors
- 14 Connecting to a 3.3 Volt Target System
- 14 Connecting to an SMBus Target System
- 15 4 ESD (Electrostatic Discharge) Precautions
- 15 Host Computer Grounding
- 16 Grounding Solutions
- 16 5 Hardware Set-Up
- 19 Part 2 - iPort Utility Pack for Windows
- 21 1 iPort Utility Pack for Windows
- 21 iPort Message Center
- 22 iPort Message Manager
- 23 2 System Requirements
- 23 3 iPort Utility Pack Installation
- 23 Installing from CD
- 23 Installing from the Web
- 24 4 iPort Message Center
- 25 Message Center Operations
- 25 Starting the Message Center
- 25 Selecting the Adapter
- 26 Select the Communications Port
- 26 Options Menu
- 26 Establish Adapter Communications Link
- 26 C Messages
- 27 C Address
- 27 Set Message Read/Write Direction
- 27 Specify Repeated Start Messages
- 28 Set Time Delay
- 28 Specify Write Data or Read Byte Count
- 29 Inserting and Deleting Messages
- 29 Saving or Loading Message Lists
- 29 Send the Message List
- 29 Special Event Handling
- 30 Slave Not Acknowledging
- 31 Command Line Arguments
- 32 Set Adapter Type
- 32 Set RS-232 Communication Port
- 32 Set RS-232 Baud Rate
- 32 C Bus Clock Rate
- 33 Enable /INT Signal Monitor
- 33 Stop On Busy
- 33 Stop On Arbitration Loss
- 33 Stop On Slave Negative Acknowledgment
- 33 Beep On Busy
- 34 Beep On Arbitration Loss
- 34 Beep On Slave Negative Acknowledgment
- 34 Beep On /INT Assert
- 34 C Message List File
- 35 Auto Open
- 35 Auto Send
- 35 Auto Exit
- 36 5 iPort Message Manager
- 37 Message Manager Operations