Rear connections. Philips FWM15/21M, FWM15

FM Antenna

Preparations

Inserting batteries into the remote control

Insert two batteries type R03 or AAA (not supplied) into the remote control with the correct polarity as indicated by the " +" and

" -" symbols inside the battery compartment.

●

For better FM stereo reception, connect an outdoor FM antenna to the FM ANTENNA terminal.

C

Speakers Connection

Front Speakers

Connect the speaker wires to the SPEAKERS terminals, right speaker to "R" and left speaker to

"L", coloured (marked) wire to " +" and black

(unmarked) wire to " -".

CAUTION!

– Remove batteries if they are exhausted or will not be used for a long time.

– Do not use old and new or different types of batteries in combination.

– Batteries contain chemical substances, so they should be disposed off properly.

1

2

●

Fully insert the stripped portion of the speaker wire into the terminal as shown.

Notes:

– For optimal sound performance, use the supplied speakers.

– Do not connect more than one speaker to any one pair of +/- speaker terminals.

– Do not connect speakers with impedance lower than the speakers supplied. Please refer to the

SPECIFICATIONS section of this manual.

PG 001-028_FWM15_21-ENG 9 23/11/04, 9:57

9

Controls

(illustrations on page 3)

Controls on the system and remote control

1

STANDBY ON y

– to switch the system on or to standby mode.

2

TUNER (BAND)

– to select waveband : FM or MW.

TAPE (TAPE 1•2)

– to select tape mode.

3

DISC 1/ DISC 2/ DISC 3 (CD 1/2/3)

– to select disc tray 1, 2 or 3.

4

DSC (DIGITAL SOUND CONTROL)

– to select the desired sound effect :

JAZZ, ROCK, TECHNO or OPTIMAL.

5

CD OPEN/CLOSE

– to open or close the disc tray.

6

DISC CHANGE

– to change disc(s).

7

DBB (DYNAMIC BASS BOOST)

– to select the desired bass boost level.

8

PROGRAM for CD ................. to programme disc tracks.

for Tuner ............. to programme preset radio stations.

for Clock ............ to select 12- or 24-hour clock mode.

9

Tape deck 1 operation

â .......................... to start recording.

É .......................... to start playback.

à / á ............... to rewind or fast forward.

70 ........................ to stop playback/recording or to open the tape door.

Å .......................... to interrupt playback or recording.

0

Tape deck 2 operation

É .......................... to start playback.

à / á ............... to rewind or fast forward.

70 ........................ to stop playback or to open the tape door.

Å .......................... to interrupt playback.

!

CLOCK•TIMER

– to view the clock, set the clock or set the timer.

@

DIM

– to select different brightness for the display screen : DIM 1, DIM 2, DIM 3 or DIM OFF.

#

n

– to connect headphones.

$

MASTER VOLUME v

w (VOL +/-)

– to increase or decrease the volume.

%

Mode Selection

PLAY•PAUSE ÉÅ for CD/MP3-CD…to start or interrupt playback.

for Plug & Play…(on the system only) to initiate and start plug & play mode.

SEARCH•TUNING à (ALBUM)

SEARCH•TUNING á (ALBUM) for MP3-CD ..... to select previous/next album.

for CD ................. to search backward/forward.

for Tuner ............. to tune to a lower or higher radio frequency.

for Clock ............ (on the system only) to set the hour.

STOP•CLEAR / DEMO STOP Ç for CD/MP3-CD…to stop playback or to clear a programme.

for Tuner ............. (on the system only) to stop programming or to erase a selected preset.

for Demo ........... (on the system only) to activate/ deactivate the demonstration.

for Clock ............ (on the system only) to exit clock setting or cancel timer. for Plug & Play…(on the system only) to exit plug

& play mode.

PREV í / PRESET 4 (TITLE)

NEXT ë / PRESET3 (TITLE) for MP3-CD ..... to select previous/next title.

for CD ................. to skip to the beginning of the, previous, or next track.

for Tuner ............. to select a preset radio station.

for Clock ............ (on the system only) to set the minute.

10

PG 001-028_FWM15_21-ENG 10 23/11/04, 9:57

^

Display screen

– to view the current status of the system.

&

Disc tray

*

REPEAT

– to playback track(s)/disc(s)/programme repeatedly.

(

SHUFFLE

– to playback all available tracks/programme of the current disc in random order.

)

MUTE

– to interrupt or resume sound reproduction.

¡

SLEEP

– to activate/deactivate or set the sleep timer.

™

B

– to switch the system to standby mode.

Notes for remote control:

– First, select the source you wish to control by pressing one of the source select keys on the remote control (CD 1/2/3 or

TUNER, for example).

– Then select the desired function ( É,

í, ë, for example).

Controls

PG 001-028_FWM15_21-ENG 11 23/11/04, 9:57

11