Loading tape. Philips FWM15/21M, FWM15

CD1 CD2 CD3

Tape Operation / Recording

IMPORTANT!

– Before playing a tape, check and tighten slack tape with a pencil. Slack tape may get jammed or may burst in the mechanism.

– C-120 tape is extremely thin and is easily deformed or damaged. It is not recommended for use in this system.

– Store the tapes at room temperature and do not put them too close to a magnetic field (for example, a transformer, TV or speaker).

Loading tape

1

Press TAPE to select TAPE mode.

➜

"

TAPE" is displayed.

2

Press

70 to open the tape deck door.

3

Load the tape with the open side downward and full spool to the left.

4

Close the tape deck door.

Playing tapes

To playback a selected tape deck

●

Press É on tape deck 1 or 2.

➜

The tape will stop at the end of playback.

Continuous playback of two tapes

1

Load the tapes in tape deck 1 and 2.

2

Press É on tape deck 2.

3

Press Å on tape deck 1, followed byÉ .

➜

Playback will begin from tape deck 2 and continue with tape deck 1. It will stop at the end of tape deck 1.

To interrupt playback

●

Press Å.

●

To resume playback, press Å again.

To stop playback

●

Press

70.

21

PG 001-028_FWM15_21-ENG 21 23/11/04, 9:58