e_kb524_84percent.book Page 69 Friday, June 15, 2012 12:13 PM
69
Using the Built-in Flash
1
Press the E button.
The built-in flash pops up and begins charging. While the flash is charging, E blinks in the viewfinder or Live View screen.
When the flash is fully charged, E stops blinking and stays lit continuously.
When you do not want the flash to discharge, keep the built-in flash retracted.
2
Take a picture.
The flash discharges.
When the flash mode is set to C or i, the flash is not discharged if the lighting conditions do not require flash for correction even when the flash is popped up.
3
Push down on the top of the flash to retract the built-in flash.
3
By default, you cannot take pictures while the built-in flash is being charged. If
you want to take pictures while charging the built-in flash, set [17. Release
While Charging] to [On] in the [A Custom Setting 3] menu.
