- Computers & electronics
- Computer components
- System components
- Internal hard drives
- Seagate
- ST3500641AS-AN
- Data Sheet
Breather filter hole precautions. Seagate ST3500641AS-AN, ST3500641AV, ST3500641A-RK
Add to My manuals68 Pages
advertisement
3.2
Breather filter hole precautions
This section contains information regarding the precautions which should be taken regarding the breather filter hole in Seagate hard disc drives. Proper precautions should be taken to ensure full functionality and prevent possible damage to the drive.
Breather hole
Do not cover or seal this hole.
Figure 3 Breather filter hole location
Caution: Do not cover, seal, or insert any object into this hole.
This hole has two purposes:
• To allow condensation inside the hard disc to escape
• To allow air pressure inside the hard disc to equalize with ambient pressure
Note.
If this hole is covered, sealed, or penetrated by any object, the drive reliability may be compromised and could lead to permanent damage. Covering or sealing this hole voids the warranty.
34 Barracuda 7200.9 PATA Product Manual, Rev. C
advertisement
Key Features
- 500 GB 3.5" 7200 RPM Serial ATA II
- Storage drive buffer size: 16 MB
- 690 g
Related manuals
advertisement
Table of contents
- 9 Introduction
- 11 Drive specifications
- 11 Specification summary table
- 26 Formatted capacity
- 26 LBA mode
- 26 Default logical geometry
- 27 Recording and interface technology
- 28 Physical characteristics
- 28 Seek time
- 28 Start/stop times
- 29 Power specifications
- 29 Power consumption
- 32 Conducted noise
- 32 Voltage tolerance
- 32 Power-management modes
- 33 Environmental specifications
- 33 Ambient temperature
- 33 Temperature gradient
- 33 Humidity
- 33 Altitude
- 34 Shock
- 34 Vibration
- 35 Acoustics
- 36 Electromagnetic immunity
- 37 Reliability
- 37 Agency certification
- 37 Safety certification
- 37 Electromagnetic compatibility
- 38 FCC verification
- 39 Environmental protection
- 39 European Union Restriction of Hazardous Substances (RoHS)
- 39 Corrosive environment
- 41 Configuring and mounting the drive
- 41 Handling and static discharge precautions
- 42 Breather filter hole precautions
- 43 Jumper settings
- 43 Master/slave configuration
- 43 Cable-select option
- 43 Alternate capacity jumper
- 44 Ultra ATA/100 cable
- 44 Drive mounting
- 47 ATA interface
- 47 ATA interface signals and connector pins
- 48 Supported ATA commands
- 50 Identify Device command
- 54 Set Features command
- 55 S.M.A.R.T. commands
- 57 Seagate Technology support services