- Home
- Domestic appliances
- Climate control
- Split-system air conditioners
- Greenheck Fan
- DGX Part #470655
- User manual
Insufficient Airflow / Too Much Airflow. Greenheck Fan DGX Part #470655, Part #470655
Add to My manuals32 Pages
advertisement
Troubleshooting
Insufficient Airflow
Damper(s) not fully opened?
Yes
No
System static losses too high?
Yes
No
Blower speed too low?
No
Filters dirty or clogged?
Yes
Yes
No
Leaks in ductwork?
Yes
No
Belt slipping?
Yes
Everything is working properly, consult factory.
Yes
Too Much Airflow
Blower speed too high?
No
Yes
Filters not in place?
No
Insufficient external static pressure?
No
Everything is working properly, consult factory.
Yes
Yes
®
Adjust damper linkage(s), or replace faulty actuator(s).
(Damper actuators may take a few minutes to open)
Reduce losses by improving ductwork.
Adjust drives as needed.
Clean or replace filters.
(Reference Filters in the Maintenance section).
Repair leaks.
Replace or tighten belt.
(Reference V-Belt Drives in the Maintenance section)
Adjust drives as needed.
(Reference Blower Start-Up – Step #5)
Install filters.
Increase external static pressure.
DGX Industrial Space Heating 19
advertisement
Related manuals
advertisement
Table of contents
- 3 Clearance to Combustibles/Service Clearances
- 4 Indoor Unit
- 5 Unit Arrangement DB / HZ
- 6 Diffuser
- 6 Remote Panel (TSCP)
- 7 Electrical Wiring
- 8 Gas Piping
- 9 Blower
- 11 Direct Gas
- 11 100% Outdoor Air
- 12 50/50 Recirculation
- 15 Electrical without 7-Day Timer
- 16 Electrical with 7-Day Timer
- 17 Blower
- 18 Motor
- 19 Insufficient Airflow / Too Much Airflow
- 20 Excessive Noise or Vibration
- 21 Heater
- 24 Routine
- 27 Gas Train Layout, 400-800 MBH
- 27 Gas Train Layout, > 800 MBH
- 28 Control Center Layout / Dirty Filter Switch
- 29 Start-Up Check List
- 30 Maintenance Log