advertisement
C Agency Regulatory Notices
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and the receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Hewlett Packard Company may void the user's authority to operate the equipment.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain compliance with FCC Rules and Regulations.
Declaration of Conformity for Products Marked with the
FCC Logo (United States Only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.
This device may not cause harmful interference.
2.
This device must accept any interference received, including interference that may cause undesired operation.
For questions regarding the product, contact:
30 Appendix C Agency Regulatory Notices ENWW
Hewlett Packard Company
P. O. Box 692000, Mail Stop 530113
Houston, Texas 77269-2000
Or, call 1-800-HP-INVENT (1-800 474-6836)
For questions regarding this FCC declaration, contact:
Hewlett Packard Company
P. O. Box 692000, Mail Stop 510101
Houston, Texas 77269-2000
Or, call (281) 514-3333
To identify this product, refer to the Part, Series, or Model number found on the product.
Canadian Notice
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Avis Canadien
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
Power Cord Set Requirements
The monitor power supply is provided with Automatic Line Switching (ALS). This feature allows the monitor to operate on input voltages between 100–120V or 200–240V.
The power cord set (flexible cord or wall plug) received with the monitor meets the requirements for use in the country where you purchased the equipment.
If you need to obtain a power cord for a different country, you should purchase a power cord that is approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked on the product's electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product. In addition, the cross-sectional area of the wire must be a minimum of 0.75 mm² or 18 AWG, and the length of the cord must be between 6 feet (1.8 m) and 12 feet (3.6 m).
If you have questions about the type of power cord to use, contact an authorized HP service provider.
A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits from the product.
ENWW Canadian Notice 31
Product Environmental Notices
Energy Star Qualification
Monitors that are marked with the ENERGY STAR Logo meet the requirements of the U.S.
Environmental Protection Agency (EPA) ENERGY STAR program. As an ENERGY STAR Partner,
Hewlett Packard Company has determined that this product meets the ENERGY STAR guidelines for energy efficiency. Specific details on using the Energy Saving features can be found in the energy saver or power management section of the computer manual.
Materials Disposal
This HP product contains mercury in the fluorescent lamp in the display LCD that might require special handling at end-of-life.
Disposal of this material can be regulated because of environmental considerations. For disposal or recycling information, contact the local authorities or the Electronic Industries Alliance (EIA) http://www.eiae.org
.
HP Recycling Program
HP encourages customers to recycle used electronic hardware, HP original print cartridges, and rechargeable batteries. For more information about recycling programs, go to http://www.hp.com/ recycle .
Chemical Substances
HP is committed to providing our customers with information about the chemical substances in our products as needed to comply with legal requirements such as REACH (Regulation EC No 1907/2006 of the European Parliament and Council). A chemical information report for this product can be found at http://www.hp.com/go/reach .
32 Appendix C Agency Regulatory Notices ENWW
advertisement
Related manuals
advertisement
Table of contents
- 7 Product Features
- 7 L2445m Model
- 8 Safety and Maintenance Guidelines
- 8 Important Safety Information
- 9 Maintenance Guidelines
- 9 Cleaning the Monitor
- 9 Shipping the Monitor
- 10 Setting Up the Monitor
- 10 Installing the Monitor Base
- 11 Rear Components
- 12 Connecting the Cables
- 14 Adjusting the Monitor
- 14 Turning on the Monitor
- 15 Using the Accessory Rails
- 16 Removing the Monitor Pedestal Base
- 17 Mounting the Monitor
- 17 Locating the Rating Labels
- 18 Operating the Monitor
- 18 Software and Utilities
- 18 The Information File
- 18 The Image Color Matching File
- 19 Installing the .INF and .ICM Files
- 19 Installing from the CD
- 19 Downloading from the Internet
- 19 Using the Auto-Adjustment Function
- 21 Front Panel Controls
- 22 Adjusting the Monitor Settings
- 22 Using the On-Screen Display Menu
- 23 OSD Menu Selections
- 27 Optimizing Digital Conversion
- 27 Identifying Monitor Conditions
- 28 Sleep Timer Mode
- 29 sRGB Support
- 29 Changing the Color Temperature
- 29 Installing the sRGB ICM File for Microsoft Windows 2000 and Windows XP
- 29 Installing the sRGB ICM File for Microsoft Windows Vista
- 30 Installing the sRGB ICM File for Microsoft Windows 7
- 31 Troubleshooting
- 31 Solving Common Problems
- 32 Online Technical Support
- 32 Preparing to Call Technical Support
- 33 Technical Specifications
- 33 L2445m Model
- 34 Recognizing Preset Display Resolutions
- 34 L2445m Model
- 35 Entering User Modes
- 35 Energy Saver Feature
- 36 Agency Regulatory Notices
- 36 Federal Communications Commission Notice
- 36 Modifications
- 36 Cables
- 36 Declaration of Conformity for Products Marked with the FCC Logo (United States Only)
- 37 Canadian Notice
- 37 Avis Canadien
- 37 Power Cord Set Requirements
- 38 Product Environmental Notices
- 38 Energy Star Qualification
- 38 Materials Disposal
- 38 HP Recycling Program
- 38 Chemical Substances
- 39 LCD Monitor Quality and Pixel Policy