Checking the System for Damage
Checking the System for Damage
This section provides instructions on what to do if your system might be damaged.
After Dropping It
Look for loose cables and obvious damage. If any cables are loose, reconnect them securely. If there is obvious damage to the system, have it serviced.
If you see no damage, turn on the system. If it works correctly, the system probably did not suffer any damage.
If the system does not work correctly, turn it off and check the adapters and memory modules to ensure that they are connected correctly. Go to “Electrical
Safety” on page 41 and follow the instructions for opening your system; then, reseat all adapters and memory modules.
If the system still does not work correctly, run the diagnostic tests from diagnostic utility menu. For information about running tests, see “Running Diagnostic Test
Programs” on page 112.
After Spilling Liquid on It
If liquid gets on the keyboard:
1. Turn off the server.
2. Unplug the keyboard from the back of the server.
3. Turn the keyboard upside down to drain excess liquid.
4. Dry off the keyboard with a lint-free cloth.
After the keyboard is completely dry, plug it in and turn on the server. If it does not work correctly, have the keyboard serviced.
If liquid gets inside the monitor:
1. Turn off the monitor.
2. Turn off the server.
3. Unplug the monitor from the server and the electrical outlet.
4. Have the monitor serviced immediately.
If liquid gets inside the server:
1. Turn off the server and all attached devices.
2. Unplug the server from the electrical outlet and all attached devices.
3. Have the server serviced immediately.
158
Netfinity 5000 Server Hardware Information and Procedures
