NORMAL RECORDING. White-Westinghouse WTV-11321B, WTV11321B

T5219.QX3 01.3.6 5:15 PM Page 20

Make sure ...

• TV/VCR power is turned on.

• Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or fast forward the tape to the point at which you want to begin recording.)

NOTE: This unit will ONLY record and view the same channel.

NORMAL RECORDING

You can ONLY watch the same TV program that is being recorded.

1

Select the channel to be recorded

Press the number buttons on the remote control or the CHANNEL

K or L button.

Remember: If the TV/VCR is connected to a cable box or satellite box, the TV/VCR must be on CH3 or CH4, then the channel to be recorded must be selected on the cable box or satellite box.

CH 10

2

Select the tape speed

Press the SPEED button to select the desired tape speed (SP/ SLP).

3

Begin recording

Press the RECORD button.

SP

REC

SP

4

Stop recording

Press the STOP button when recording is completed.

OTR (One Touch Recording)

This function enables you to set a recording length simply by pressing the REC/OTR button on the

TV/VCR.

Make sure ...

• TV/VCR power must be turned on.

• Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or fast forward the tape to the point at which you want to begin recording.)

NOTES:

• This function CANNOT be done from the remote control.

• Recording starts immediately when the REC/OTR button is pressed.

• When the REC/OTR button is pressed 18 times, the

TV/VCR returns to the Normal Recording mode.

• To stop the OTR operation, press the STOP button on the TV/VCR or on the remote control.

• To show the remaining time, press the DISPLAY button on the remote control so that “OTR” appears on the TV screen. (It will show up momentarily then disappear.)

• Recording stops when 0:00 is reached.

• Please note that in the SLP mode maximum recording time, assuming the tape is started at the beginning, is 8 hours using T-160 (or 6 hours using T-120).

• If the tape runs out before the end time, the

TV/VCR will switch to the Stop mode immediately, eject the tape and turn itself off.

SKIPPING UNWANTED

SCENES DURING RECORDING

Press the PAUSE/STILL button to temporarily stop recording.

PAUSE

Press the PAUSE/STILL or

RECORD button to resume recording.

SP

NOTES:

• After five minutes, the TV/VCR will automatically switch to the Recording mode to prevent tape damage.

• If “CLOSED CAPTION (ON)” is selected, the On-

Screen Display will appear for 5 seconds, then disappear.

1

Select the channel to be recorded

Press the number buttons on the remote control or the

CHANNEL K or L button.

Remember: If the TV/VCR is connected to a cable box or satellite box, the TV/VCR must be on CH3 or

CH4, then the channel to be recorded is selected on the cable box or satellite box.

2

Select the tape speed

Press the SPEED button to select the desired tape speed (SP/ SLP).

- 20 EN

01A11