advertisement
EMERGENCY ACTIVATION KEYS
NOTE: You must hold these keys for 2 seconds to activate these functions. Your system may not be programmed for these activation keys (see page 1). You should press these keys only in an emergency situation that requires response by emergency personnel. If your system is programmed for these functions, the following reports can be sent.
Fire Key – This key can activate the fire alarm when pressed for two seconds.
If your system is connected to a monitoring centre, an emergency report could be sent to that centre.
Auxiliary Emergency Key – This key can activate the auxiliary alarm when pressed for two seconds. If your system is connected to a monitoring centre, an emergency report could be sent to that centre.
Police (Panic/Hold-Up) Key - This key can sound a local audible alarm when pressed for two seconds. If your system is connected to a monitoring centre, an emergency report could be transmitted to that centre. NOTE: Some
Panic/Hold-Up alarms are programmed to be silent at the protected site while reporting an alarm to the monitoring centre. Check with your installation company to determine how your security system will respond to the
Panic/Hold-Up activation.
7
advertisement
Related manuals
advertisement
Table of contents
- 4 GLOSSARY OF TERMS
- 4 Abort Delay
- 4 Authority Level
- 4 Central Station
- 4 Chime
- 4 Codes
- 4 Duress Code
- 4 Forced Arming
- 4 Function Code
- 4 Group Bypass
- 4 Master Code
- 4 Partial Arm
- 4 Perimeter
- 4 Quick Arm
- 4 User Code
- 5 UNDERSTANDING THE LIGHTS
- 5 Armed Light
- 5 Bypass Light
- 5 Chime Light
- 5 Exit Light
- 5 Fire Light
- 5 On Light
- 5 Partial Light
- 5 Power Light
- 5 Ready Light
- 5 Zone Light
- 6 SERVICE MENU
- 7 EMERGENCY ACTIVATION KEYS
- 7 CODE PAD FUNCTIONS
- 7 Arming in the "On" Mode
- 8 Arming System in "Partial" Mode
- 8 Using the Quick Arm
- 8 Disarming the System
- 8 Bypassing
- 9 Un-bypassing
- 9 Group Bypass
- 9 Turning the Door Chime On and Off
- 9 CHANGING CODES
- 9 ASSIGNING USER CODE AUTHORITY
- 10 OTHER CODE PAD FUNCTIONS
- 10 View Alarm Memory
- 10 Reset Smoke Detectors
- 12 Managing Phone Numbers
- 12 Communicator Test Function
- 13 Set System Date
- 13 Set System Clock
- 13 Set Code Pad Tone
- 14 Code Pad Control Tones
- 15 Emergency Evacuation Plan