advertisement
USER PROGRAMMABLE TELEPHONE NUMBERS
When pager or siren tone formats are selected, any of the three phone numbers may be programmed or altered in the run mode. You must use the following procedure to enter the phone numbers.
Step 1
Step 2.a
Press the [4]-[1] key. (For phone number one (1) )
Step 2.b
Press the [4]-[2] key. (For phone number two (2) )
Step 2.c
Press the [4]-[3] key. (For phone number three (3) )
Step 3 Enter a “Master Arm/Disarm Code”.
Step 4
Key
Now enter the required number, not exceeding 20 digits. Use the following table to determine Key values.
Phone Digit Key Phone Digit
[1]
[2]
[3]
[4]
1
2
3
4
[9]
[0]
[ON]
[PARTIAL]
9
0
Star (r)
Pound (#)
[5]
[6]
[7]
[8]
7
8
5
6
[EXIT]
[BYPASS]
[CHIME]
4 Sec Delay
Disable
Pulse Dialing
Step 5 Press [#] to end and exit.
VIEWING TELEPHONE NUMBERS
When pager or siren tone formats are selected, any of the three phone numbers may be viewed in the run mode. You must use the following procedure to view the phone numbers.
Step 1 Press the [r] key.
Step 2.a
Press the [4]-[1] key. (For phone number one (1) )
Step 2.b
Press the [4]-[2] key. (For phone number two (2) )
Step 2.c
Press the [4]-[3] key. (For phone number three (3) )
Step 3 Enter a “Master Arm/Disarm Code”.
Now you are in the view mode and the first phone digit will be displayed. Use the following table to read the code pad lights. Go to step 4 to view the rest of the phone number.
Step 4 Press the [r] key to move to the next digit.
12
advertisement