advertisement
Front Door Latch and Door Lock Actuator Assembly
SECURITY AND LOCKS
6. Front Door Latch and Door
Lock Actuator Assembly
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the front door trim. <Ref. to EI-48, RE-
MOVAL, Door Trim.>
3) Remove the wires from front inner remote. <Ref.
to SL-28, REMOVAL, Front Inner Remote.>
4) Remove the sealing cover. <Ref. to EB-20, RE-
MOVAL, Front Sealing Cover.>
5) Remove the front door glass. <Ref. to GW-10,
REMOVAL, Front Door Glass.>
6) Remove the rear sash. <Ref. to GW-15, RE-
MOVAL, Front Regulator and Motor Assembly.>
7) Remove the key cylinder cover B, and remove the key rod from key cylinder. (Model with double lock)
8) Open the handle rod cover of latch assembly.
9) Remove the three screws.
SL-00281
10) Remove the front door latch & door lock actuator assembly, and disconnect the connector.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Make sure the lock works correctly after installation.
C: INSPECTION
1) Check the rod, outer wire and inner wire for deformation. When it is deformed, straighten it because failure operations may occur. When it is unrepairable, replace the front door latch & door lock actuator assembly.
2) Check the lever, rod and wire for smooth operation.
SL-30
advertisement
Related manuals
advertisement
Table of contents
- 4 General Description
- 12 Door Lock Control System
- 17 Keyless Entry System
- 30 Front Inner Remote
- 31 Front Outer Handle
- 32 Front Door Latch and Door Lock Actuator Assembly
- 33 Front Door Lock Actuator
- 34 Rear Inner Remote
- 35 Rear Outer Handle
- 36 Rear Door Latch and Door Lock Actuator Assembly
- 37 Rear Door Lock Actuator
- 38 Rear Gate Outer Handle
- 39 Rear Gate Latch Assembly
- 41 Trunk Lid Lock Assembly
- 42 Front Hood Lock Assembly
- 43 Remote Openers
- 45 Ignition Key Lock
- 46 Key Lock Cylinders
- 47 Keyless Entry Control Unit
- 48 Body Integrated Unit
- 49 Keyless Transmitter
- 51 Immobilizer Control Unit
- 52 Immobilizer Antenna