Non-Critical. Remote Automation Solutions OpenEnterprise NW3000
Add to My manuals32 Pages
Remote Automation Solutions OpenEnterprise NW3000 is a network gateway device that allows you to integrate your Bristol devices with other systems, such as a SCADA system or a historian. It supports a variety of communication protocols, including Modbus, DNP3, and OPC UA. This allows you to connect to a wide range of devices, regardless of their manufacturer.
The NW3000 also provides a number of features that make it easy to manage and monitor your devices. These features include:
- A web-based interface that allows you to configure and monitor the device from anywhere in the world
- Remote alarm support that allows you to receive alarms from your devices via email or text message
advertisement
![Non-Critical. Remote Automation Solutions OpenEnterprise NW3000 | Manualzz Non-Critical. Remote Automation Solutions OpenEnterprise NW3000 | Manualzz](http://s1.manualzz.com/store/data/008460384_1-128800b4516a0c04e7fe400b0c9c11ba-360x466.png)
Reference Guide
D301509X412
April 2012
3.4.4 Non-Critical
NW3000 Setup
If checked, non-critical priority return-to-normal alarm reports will require user acknowledgement.
3.4.5 Operator Guide
If checked, operator-guide priority return-to-normal alarm reports will require user acknowledgement.
3.4.6 Event
If checked, event priority return-to-normal alarm reports will require user acknowledgement.
3.5 RBE Support
The RBE Support dialog enables the user to configure Report By Exception (RBE) data collection for all devices.
- 9 -
advertisement
Related manuals
advertisement
Table of contents
- 7 Automatically Start OpenBSI
- 7 Automatically Stop OpenBSI
- 7 Network Definition File
- 7 Number of seconds between subsequent start attempts
- 7 Number of times to retry OpenBSI start-up
- 7 Cancel Button
- 8 Help Button
- 8 Maximum total number of pending requests
- 9 Maximum number of pending requests per device
- 10 Number of seconds between device health checks
- 10 Number of devices per health check
- 10 Number of consecutive failures allowed
- 11 Enable Remote Alarm Support
- 11 Acknowledge Return to Normal Reports
- 11 Critical
- 12 Non-Critical
- 12 Operator Guide
- 12 Event
- 13 RBE Data Collection
- 14 Active Polling for NW3000 Analogs
- 14 Active Polling for NW3000 Digitals
- 14 Active Polling for NW3000 Strings
- 14 Active Polling Frequency
- 15 Include RBE Signals in Active Polling
- 15 Background Polling Frequency
- 15 One Shot Poll
- 15 Maximum Interval
- 15 Offset
- 16 Analog Alarms
- 21 System Setup Finish Button
- 22 All Devices
- 23 Single Device
- 23 Use Settings
- 24 Enable RBE Data Collection for Device
- 24 Scan Rate
- 24 Scan Slice
- 24 Timeout
- 25 StopXmit
- 26 Use Settings Here for Polling Support
- 26 Create a Unique Timeclass for each Device
- 26 Polling Frequency
- 28 Device Setup Finish Button