advertisement
Installation
This chapter gives step-by-step installation instructions for the Converter.
Selecting a Site for the Equipment
As with any electric device, you should place the equipment where it will not be subjected to extreme temperatures, humidity, or electromagnetic interference.
Specifically, the site you select should meet the following requirements:
1. The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees
2.
3.
Celsius).
The relative humidity should be less than 90 percent, non-condensing.
Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for
4.
5.
IEC 801-3, Level 2 (3V/M) field strength.
Make sure that the equipment receives adequate ventilation. Do not block the ventilation holes on each side of the switch or the fan exhaust port on the side or rear of the equipment.
The power outlet should be within 1.8 meters of the switch.
5
Connecting to Power
1. This Converter is a plug-and-play device.
2. Connect the supplied AC to DC power adaptor with a power voltage of 7.5Vdc/1.5Amp to the receptacle on the rear panel of the converter, and then attach the plug into a standard AC outlet with a voltage range from 100 to 260 Vac.
Dip Switch
There is a dip switch for duplex mode setting for fiber port. Refer to the table below for more details.
ON
1
Switch 1 : On -> Fiber Half Duplex
Off -> Fiber Full Duplex
On Half Off
6
Installing in a Chassis
The Converter can be fit into any of the expansion slots on a special designed chassis.
Unscrew and pull out the media converter board
First, install the converter onto a carrier supplied with the chassis:
Step 1- Unscrew the carrier from the desired expansion slot on the chassis.
Step 2- Remove the screw on the converter as shown below.
Step 3- Fit the converter onto the carrier and use the screw to secure it.
7
advertisement
Related manuals
advertisement