Specifications AccuSync LCD203WM Monitor. NEC AccuSync® LCD203WM, LCD203WM, AccuSync® LCD193WM, LCD223WM, AccuSync LCD223WM, AccuSync® LCD223WM, LCD193WM

Specifications AccuSync LCD203WM Monitor

Monitor Specifications AccuSync LCD203WM Monitor Notes

LCD Module

Input Signal

Display Colours

Diagonal:

Viewable Image Size:

Native Resolution (Pixel Count):

51.1 cm/20.1 inches

51.1 cm/20.1 inches

1680 x 1050

Active matrix; thin film transistor (TFT) liquid crystal display (LCD); 0.258 mm dot pitch; 300 cd/m 2 white luminance, 1000:1 contrast ratio, typical.

Video: ANALOG 0.7 Vp-p/75 Ohms

Sync: Separate sync.TTL Level (Positive/Negative)

Horizontal sync. Positive/Negative

Vertical sync. Positive/Negative

Analog input: 16,7 M Depends on display card used.

Synchronization Range Horizontal: 31.5 kHz to 82.3 kHz

Vertical: 56 Hz to 75 Hz

Viewing Angle Left/Right: -85°/+85° (CR>5)

Up/Down: -85°/+85° (CR>5)

Automatically

Automatically

Resolutions Supported Landscape: 720 x 400* 1 : VGA text

640 x 480* 1 at 60 Hz to 75 Hz

800 x 600* 1 at 56 Hz to 75 Hz

832 x 624* 1 at 75 Hz

1024 x 768* 1 at 60 Hz to 75 Hz

1152 x 864* 1 at 75 Hz

1152 x 870* 1 at 75 Hz

1280 x 960* 1 at 60 Hz to 75 Hz

1280 x 1024* 1 at 60 Hz to 75 Hz

1440 x 900* 1 at 60 Hz

Some systems may not support all modes listed.

Recommended resolution is 60 Hz for

1680 x 1050 at 60 Hz.................................. optimal display performance.

Active Display Area

Speakers

Horizontal: 433.4 mm

Vertical: 270.9 mm

Practical Audio Output: 1.0 W + 1.0 W

Power Supply

Dimensions

100 - 240 V ~ 50/60 Hz

Landscape: 478.9 mm (W) x 386.8 mm (H) x 196.2 mm (D)

18.9 inches (W) x 15.2 inches (H) x 7.7 inches (D)

Weight 6.1 kg

Environmental Considerations

Operating Temperature: 5 °C to 35 °C

Humidity: 30% to 80%

Altitude: 0 to 3,048 m

Storage Temperature: -10 °C to +60 °C

Humidity: 10% to 85%

Altitude: 0 to 12,192 m

*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.

NOTE: Technical specifications are subject to change without notice.

English-12