Driver Memory Seat and Mirrors. Buick LeSabre 2004, 2004 LeSabre

15778 LeSABRE GUIDE 5/22/03 1:55 PM Page 16

16

Getting to Know Your 2004 LeSabre

New Key

If a new ignition key is required, it should be purchased at a Buick dealership. The key is matched to your vehicle’s module. The module will then learn the new transponder key code.

See Section 2 of your Owner Manual.

To recall the memory seat and mirrors using the key fob/transmitter, program the DIC Seat Recall feature to ON.

See Section 2 of your Owner Manual.

Driver Memory Seat & Mirrors

(optional)

With the vehicle in PARK (P), adjust the driver’s seat, including the lumbar position (optional) and both outside mirrors to a comfortable position. This feature also recalls the radio and climate control settings. However, it does not include the power head restraint settings.

Driver Information Center (DIC)

(optional)

The DIC displays information about how your vehicle is functioning and shows warnings and messages if a system problem is detected.

StabiliTrak ® Message

When the “STABILITY SYS ACTIVE” message appears, a computercontrolled system is automatically activated. Some brake pedal noise or vibration is normal. (StabiliTrak is an optional feature.)

DIC Button Descriptions

• Press and hold the appropriate

Driver/MEMORY button (located on the driver’s door panel), to correspond with the DIC Driver number, until you hear two beeps.

• Follow the previous step with the other key fob/transmitter to set up for a second driver, and select the other

Driver/MEMORY button.

• Press and release the EXIT button.

With the transaxle in PARK (P), the seat will move all the way back or to your personalized exit position.

• Press the ODO/TRIP button to display the vehicle’s total mileage, and

Trip 1 or Trip 2 miles. Press the

ODO/TRIP button for the appropriate trip number, then press the RESET button to reset the trip odometer.

• Press the FUEL INFO button to display fuel economy, fuel average, fuel instantaneous, fuel range and fuel used. Press the ODO/TRIP button for the appropriate trip number, then press the RESET button while the