L-INX/L-GATE User Manual 90 LOYTEC
8.2 Statistics on the Console
8.2.1 Connecting to the Console
Use a PC terminal program with the communication settings set to 38,400 bps / 8 data bits / no parity / 1 stop bit / no handshake. To connect COM1 of the PC to the Console on the device, use a standard null-modem cable with full handshaking. Power up the device or
press Return if the device is already running. The menu shown in Figure 70 should appear
on the terminal.
Device Main Menu
================
[1] Show device information
[2] Serial firmware upgrade
[3] System configuration
[4] CEA-709 configuration
[5] IP configuration
[6] CEA-852 device configuration
[7] CEA-852 server configuration
[8] Reset configuration (factory defaults)
[9] Device statistics
[c] Modbus cofiguration
[a] Data Points
[0] Reset device
Please choose:
Figure 70: Console Main Menu.
8.2.2 Reset configuration (load factory defaults)
Select item ‘8’ in the console main menu. This menu item allows resetting the device into its
factory default state. The menu appears as shown in Figure 71.
Reset Configuration Menu
========================
[1] Reset everything to factory defaults
[3] Reset all passwords
[4] Clear data point configuration
[q] Quit
Please choose:
Figure 71: Reset to Factory Defaults Menu.
Select option ‘1’ to reset the entire device to factory defaults (including error log, configuration files, passwords etc.). Select option ‘3’ to reset all passwords (Web interface,
FTP server etc.) to factory defaults.
Select option ‘4’ to clear all configured data points, such as CEA-709 network variables or user registers. This effectively clears the entire port configuration. The device must be rebooted to let the changes take effect.
Note: This option does not reset the configuration of the built-in CEA-709 router. The nodes connected by the router are still reachable after clearing the data point configuration.
8.2.3 Device Statistics Menu
Select ‘9’ from the device main menu to get to the device statistics menu. This menu holds relevant information regarding the device statistics of the device. This section describes those statistics, which are not available on the Web UI. The device statistics menu is shown
in Figure 72. Use this menu only for debugging purposes. There is no need to access this
menu if the network is running smoothly.
Version 6.1
LOYTEC electronics GmbH
