G88. X axis grooving canned cycle. Fagor CNC 8055 para otras aplicaciones, CNC 8055 for lathes, CNC 8055 para tornos, CNC 8055 for other applications

9.

Programming manual

9.11

G88. X axis grooving canned cycle

This cycle performs a grooving operation along the X axis maintaining the same pass between the successive passes being this equal to or smaller than the one programmed.

The basic structure of the block is:

G88 X Z Q R C D K

CNC 8055

CNC 8055i

X±5.5

Defines the X coordinate of the initial point of the groove. It must be programmed in absolute coordinates and in the active units, radius or diameter.

Z±5.5

Defines the Z coordinate of the initial point of the groove. It must be programmed in absolute coordinates.

Q±5.5

Defines the X coordinate of the final point of the groove. It must be programmed in absolute coordinates and in the active units, radius or diameter.

R±5.5

Defines the Z coordinate of the final point of the groove.

C5.5

Defines the grooving pass.

If not programmed, the CNC will assume the width of the cuttter (NOSEW) of the active tool and if programmed with a zero value, the CNC will issue the corresponding error message.

D5.5

Defines the safety distance and it must have a positive value in radius.

K5

Defines the dwell, in hundredths of a second, after each penetration until the withdrawal begins.

If not programmed, a value of 0 is assumed.

·T· M ODEL

S OFT : V01.6

X

·202·