advertisement
Installation Instructions
INSTALLATION
Adding a lift arm modifies your mount configuration. This procedure applies to most small flat panel displays, particularly those with a pivot or swing arm, whether wall mount or desk mount.
Removing the Display from the Mount
To remove the display from its mount, perform the following steps:
NOTE: Do not remove the four screws (not shown) that attach the display to the interface bracket.
1. Disconnect the power/audio/video cables from the display (not shown).
2. Remove the cap screw, washers, pivot pin, and retaining nut from the display end of the mount.
Refer to Figure 2. Separate the display from the mount.
FSA/KSA-1004
3. To remove the pivot pin (see Figure 2) from the other end, do the following: a. If the mount is a pivot/pitch wall mount, remove the attaching hardware from the display. b. If the mount is wall mounted, desk mounted, or has more than one swing arm, remove the attaching hardware from the arm closest to the display.
NOTE: The two button head cap screws removed from the mount will be replaced with longer screws when the lift arm is installed.
NOTE: Keep the pivot pin removed in step 2. This part will be used again when the lift arm is installed.
Cap screw
Small
Washer
Pivot Pin
Large
Washer
Flat Washers
Display Mount Parts — Typical
PART NAME QTY
SCREW , CAP 2
WASHER , FLAT 4
SMALL WASHER , NYLON 2
LARGE WASHER , NYLON 2
NUT , NYLOCK 2
Nut
Figure 2. Single Swing Arm (FWS-110) — Example
4
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project