Troubleshooting. Insignia NS-CLVR01

NS-CLVR01_10-0138_MAN_ENG_V2.fm Page 17 Tuesday, February 2, 2010 3:04 PM

Insignia NS-CLVR01 Clock Radio with Voice Command

3 Press the PRESET button repeatedly to select the preset station you want.

Note

You can also recall presets using voice commands if a name

is recorded for the preset station. See “Using voice commands” on page 10.

Troubleshooting

Problem Cause/Solution

No power

Static or noise when playing the radio

The sound is distorted

• Make sure that the AC power adapter is fully inserted into the

AC power outlet.

• Make sure that the AC power outlet is working.

No sound from the speakers

Make sure that the volume level is set correctly.

• Make sure that the station is tuned correctly and that the station has a good signal.

• Try another station.

• If you are playing an AM station, rotate the clock radio to improve the reception.

• If you are playing an FM station, extend the antenna wire to improve the reception.

• Make sure that the volume level is not set too high.

• Make sure that the material on the sound source is not distorted. Try a different external sound source.

The clock radio gets warm after extended play at high volume levels

This is normal.

The clock radio does not respond when I give a command

Make sure that the VC ON/OFF button on the back of the clock radio is turned On. When it is On, you should see the VC icon on the display.

The clock radio does not hear my commands

You cannot give a command while the clock radio is on. Avoid background noise when talking to this clock radio as well.

The clock radio cannot recognize my commands

Depending on the ambient noise and how you speak, there may be times when the radio will not understand your commands. If this happens, just repeat the commands (see below regarding pronunciation), the clock radio should respond properly.

www.insigniaproducts.com

17