advertisement
▼
Scroll to page 2
of
42
Maintenance
5.8
Auto Idle Speed
G/GS 5.6A
See Graphic: wc_gr000548
5.8.1
Adjust pilot screw on carburetor as described above.
5.8.2
Loosen clamping screw (b) on auto idle magnet bracket.
5.8.3
Start engine and set auto idle switch to "Auto".
5.8.4
Turn magnet pin (a) in or out to adjust idle speed to 2200 ± 50 rpm.
Note: To avoid excessive vibration and to maintain adequate cooling ability, do not set engine auto idle speed lower than 2200 rpm.
5.8.5
Re-tighten clamping screw.
wc_tx000164gb.fm
32
advertisement
Related manuals
Frequently Answers and Questions
What type of fuel does the G5.6A generator use?
The G5.6A generator uses unleaded gasoline with a minimum octane rating of 87.
How many receptacles does the G5.6A generator have?
The G5.6A generator has two 120V receptacles and one 240V receptacle.
What is the maximum wattage that the G5.6A generator can produce?
The G5.6A generator can produce a maximum of 5,600 watts of power.
Does the G5.6A generator have an electric start?
No, the G5.6A generator does not have an electric start. It must be started manually with a recoil starter.
How long can the G5.6A generator run on a full tank of fuel?
The G5.6A generator can run for up to 8 hours on a full tank of fuel at 50% load.
advertisement