CONNECTIONS. Yamaha YST-SW015

CONNECTIONS

Caution: Plug in the subwoofer and other audio/video components after all connections are completed.

Connect the subwoofer to the line output (pin jack) terminal(s) of the amplifier.

● To connect with a YAMAHA DSP amplifier (or AV receiver), connect the SUBWOOFER (or LOW PASS etc.)

● When connecting the subwoofer to the SPLIT

SUBWOOFER terminals on the rear of the DSP amplifier, terminal on the rear of the DSP amplifier (or AV receiver) to the L/MONO INPUT terminal of the subwoofer.

be sure to connect the L/MONO INPUT terminal to the

“L” side and the R INPUT terminal to the “R” side of the

SPLIT SUBWOOFER terminals.

Right main speaker

Subwoofer cable

(not included)

Left main speaker

Subwoofer

/MONO

INPUT

AUTO

STANDBY

PHASE

OFF LOW HIGH NORM REV

ON

POWER

OFF

110V–120V 220V–240V

VOLTAGE

SELECTOR

/MONO

INPUT

AUTO

STANDBY

PHASE

OFF LOW HIGH NORM REV

To AC outlet

Audio pin cable

(not included)

SPLIT SUBWOOFER

Amplifier

SUBWOOFER

( LOW PASS)

E-

4

Notes

● Some amplifiers have line output terminals labeled PRE

OUT. When you connect the subwoofer to the PRE OUT terminals of the amplifier, make sure that the amplifier has at least two sets of PRE OUT terminals. If the amplifier has only one set of PRE OUT terminals, do not connect the subwoofer to the PRE OUT terminals.

SW015(UB) (03.2.28)a 4

● When connecting to a monaural line output terminal of the amplifier, connect the L/MONO INPUT terminal.

03.2.28, 7:25 PM