Specifications. NEC AccuSync AS222Wi

Specifi cations

Monitor Specifi cations AccuSync AS222Wi Monitor

LCD Module Diagonal:

Viewable Image Size:

Native Resolution (Pixel Count):

54.62 cm/21.5 inches

54.62 cm/21.5 inches

1920 x 1080

Notes

Active matrix; thin fi lm transistor (TFT) liquid crystal display (LCD); 0.248 mm dot pitch; 250 cd/m 2 white luminance; 1000:1 contrast ratio (typical), (5000:1

Contrast ratio, DV MODE ON).

Input Signal

DVI:

VGA:

DVI-D 24pin: Digital RGB

15pin Mini D-sub: Analog RGB

Sync

16,777,216 Display Colors

Synchronization Range Horizontal:

Vertical:

Viewing Angle Left/Right:

Up/Down:

Resolutions Supported (Some systems may not support all modes listed).

31.5 kHz to 81.1 kHz

56 Hz to 75 Hz

±89° (CR > 10)

±89° (CR > 10)

DVI (HDCP)

0.7 Vp-p/75 ohm

Separate sync.TTL level Positive/Negative

Depends on display card used.

Automatically

Automatically

720 x 400* 1 VGA text

640 x 480* 1 at 60 Hz to 75 Hz

800 x 600* 1 at 56 Hz to 75 Hz

832 x 624* 1 at 75 Hz

1024 x 768* 1 at 60 Hz to 75 Hz

1152 x 870* 1 at 75 Hz

1280 x 960* 1 at 60 Hz

1280 x 1024* 1 at 60 Hz to 75 Hz

1440 x 900* 1 at 60 Hz

1680 x 1050* 1 at 60 Hz

1920 x 1080 at 60 Hz........................................... NEC DISPLAY SOLUTIONS cites recommended

resolution for optimal display performance.

Active Display Area Horizontal:

Verttical:

Power Supply

Current Rating

Dimensions

Weight

Environmental Considerations

Landscape:

476.1 mm/18.7 inches

267.8 mm/10.5 inches

100 - 240 V ~ 50/60 Hz

0.45 - 0.25 A

507.4 mm (W) x 364.7 mm (H) x 205.1 mm (D)

20.0 inches (W) x 14.4 inches (H) x 8.1 inches (D)

4.1 kg (9.0 lbs)

Humidity:

Altitude:

20% to 80%

0 to 6,562 Feet/0 to 2,000 m

Humidity:

Altitude:

10% to 85%

0 to 40,000 Feet/0 to 12,192 m

*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is normal and necessary for all current fl at panel technologies when displaying non-native resolutions full screen. In fl at panel technologies, each dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.

NOTE: Technical specifi cations are subject to change without notice.

English-12