Device Groups. Multitech MTCDTIP-LDC3-266A-923-JP, MTCDT-L4N1-247A-915-US, MTCAP-L4E1-868-041A, MTCDTIP-L4N1-266A-915, MTCDT-H5-246A-868-EU-GB, MTCDT-LVW2-246L-US, MTCDT-H5-246A-US-EU-GB, MTCDTIP-LAT1-266A-915, MTCDT-246A-STARTERKIT-915, MTCDTIP-LVW2-270L-915
Reklama
Reklama
LORAWAN
However, you can use the Device Sessions section, if you want to create a session manually, otherwise known as
ABP (Activation by Personalization). The manual session includes only the gateway and end-devices. The server is not involved.
To add a new session manually:
1.
Go to LoRaWAN > Devices .
2.
Under Sessions , click Add New .
3.
Enter the following fields: a.
Dev EUI - End-device EUI (Extended Unique Identifier) b.
Dev Addr - Network device address assigned to end-device c.
App EUI - Application EUI d.
Join EUI - Join Request EUI e.
Net ID - Network ID f.
App Session Key - Pre-shared application session key g.
Net Session Key - Derived network session key based on pre-shared application key
4.
Click Finish .
5.
The new session displays under the Sessions list including some device details and statistics.
a.
Dev EUI - End-device EUI (Extended Unique Identifier) b.
Dev Addr - Network device address assigned to end-device c.
Up FCnt - Packet counter of last received packet d.
Down FCnt - Packet counter of last sent packet e.
Last Seen - Time of last packet received f.
Joined - What is the device joined to, Cloud or local version g.
Details - Additional session information (click on info icon)
6.
To edit the session, click the pencil icon, or to delete it, click the x icon next to that session.
Device Groups
This page allows you to create Device Groups in order to perform mass firmware upgrade OTA and multicast messaging to all devices in that group.
The Groups table displays existing groups. Use the View , Edit, or Remove buttons to see, modify, or delete an existing group in the table.
To create a new device group:
1.
Go to LoRaWAN > Device Groups .
2.
Click the Add New button.
3.
The Add Group dialog box appears. Enter your desired Group Name .
4.
You can also enter an optional Group EUI . If you do not provide one, the system generates a Group EUI automatically.
5.
Select the desired end device(s) to include in your group by clicking the box next to each Device EUI .
6.
Click Add .
30 mPower TM Edge Intelligence Conduit AEP Software Guide
Stáhnout
Reklama