LORAWAN
Rx1 DR Offset
Rx2 DR Index
Rx2 Frequency
Channel Mask
US
EU
Redundancy default datarate offset of first Rx window, if not provided the LoRaWAN default for the selected channel plan will be used default datarate of second Rx window, if not provided the LoRaWAN default for the selected channel plan will be used default frequency of second Rx window, if not provided the LoRaWAN default for the selected channel plan will be used bitmask of enabled channels, US/AU use a twenty character mask, other use a four character mask first 2 characters are not used, the next two control the
500 KHz channels: enable all channels – 00FFFFFFFFFFFFFFFFFF enable bottom half - 000F00000000FFFFFFFF enable all channels - FFFF number of times an unconfirmed uplink should be repeated
Packets
This section shows three lists: transmitted, recent join requests, and recently received packets on the LoRa network. Each packet includes relevant packet details.
Packets (Transmitted)
Item
Device EUI
Freq
Datarate
SNR
CRC
RSSI
Size
FCnt
Description
End-device EUI (Extended Unique Identifier) transmitting the uplink packet or destination of the downlink packet
Frequency used to transmit packet
Datarate used to transmit packet
Signal to noise ratio of received packet
Cyclic redundancy check failed
Received signal strength
Size in bytes of packet
MAC packet counter
34 mPower TM Edge Intelligence Conduit AEP Software Guide
LORAWAN
Type Type of packet includes these possible values:
JnAcc - Join Accept Packet
JnReq - Join Request Packet
UpUnc - Uplink Unconfirmed Packet
UpCnf - Uplink Confirmed Packet - ACK response from network requested
DnUnc - Downlink Unconfirmed Packet
DnCnf - Downlink Confirmed Packet- ACK response from end-device requested
Time packet was sent or received
Additional packet details (click on info icon to view popoup)
Tx/Rx Time
Details
Recent Join Requests
Item
Join EUI
Nonce
Elapsed
Result
Description
8-byte EUI (Extended Unique Identifier) found in the join request
Join nonce provided by end-device in the Join Request
Round trip time in milliseconds for the Join Server to service the join request
If the result of the request is valid, it displays: Success .
If the result is an error, one of the following displays:
MICFailed - AppKey setting did not match the end-device record in Join Server
Dropped - Downlink packet could not be scheduled for transmit on any available gateways
Duplicate Dev Nonce - Nonce in join request has already been used
JoinReq Failed - Other server error
UnknownDevEUI - Device record was not found at Join Server
Gateway Mismatch - Join Server configuration does not allow this device to join through this gateway
Server Error - Join Server is not reachable possibly due to Internet connection settings or DNS resolution
Recent Rx Packets
Item
Time mPower TM Edge Intelligence Conduit AEP Software Guide
Description
Time packet was received
35
