Vertical storage. Greenworks Pro MO60L423

• Make sure that the machine does not have loose or damaged parts. If it is necessary, do these steps/ instructions:

• Replace the damaged parts.

• Tighten the bolts.

• Speak to a person at an approved service center.

• Store the machine in a dry area.

• Make sure that children cannot come near the machine.

9.4

VERTICAL STORAGE

English

1. Remove the grass catcher.

2. Remove the battery and safety key.

3. Pull through the handle holes to fold away the handles.

4. Lock the handles into position.

5. Stand the machine on end and make sure that the brackets touch the floor.

10 TROUBLESHOOTING

Problem

The handle is not in position.

Possible cause

The bolts are not engaged correctly.

Solution

Adjust the height of the handle and make sure that the bolts and nuts are aligned correctly.

Problem

The machine does not start.

The machine cuts grass unevenly.

The machine does not mulch correctly.

The machine is hard to push.

There is a high vibration in the machine.

Possible cause

The battery capacity is low.

The start handle is defective.

The battery key is not put in.

Solution

Charge the battery pack.

Replace the start handle.

Put in the battery key.

The lawn is rough. Examine the mowing area.

The blade height is not set correctly.

Move the wheels to a higher position.

Wet grass clippings attach to the deck.

The mulch plug is missing.

The grass is too tall, or the blade height is too low.

The grass catcher and the blade drags in thick grass.

The blade is unbalanced and worn.

Wait until the grass dries before mowing.

Install the mulch plug.

Increase the blade height.

Empty the grass clippings from the grass catcher.

Replace the blade.

The machine stops during mowing.

The motor shaft is bent.

1. Stop the motor.

2. Remove the safety key and battery pack.

3. Disconnect the power source.

4. Inspect for damage.

5. Repair the machine before you start it again.

The blade height is too low.

Increase the blade height.

The battery pack is out of power.

Charge the battery pack.

The grass clippings attach to the deck or the blade.

Remove the battery pack and check the deck.

Operation temperature of the machine is too high.

Cool the machine.

EN

13