advertisement
O2 Monitor Test
OBD II regulations set by the (Society of Automotive Engineers) SAE require vehicles monitors and tests on the oxygen (O2) sensors to identify problems related to fuel efficiency and vehicle emissions. These tests are done automatically when engine operating conditions are within specified limits.
These test results are saved in the vehicle’s on-board computer's memory.
The O2 Monitor Test function allows retrieval and viewing of O2 sensor monitor test results for the most recently performed tests from the vehicle's on-board computer.
The O2 Monitor Test function is not supported by vehicles that communicate using a controller area network (CAN). For O2 Monitor Test results of
CAN-equipped vehicles, see chapter
“On-Board Mon. Test”.
1) Use the UP/DOWN scroll button to select O2 Monitor Test from
Diagnostic Menu and press OK button
.
2) Wait while the scan tool validates the PID MAP.
3) Use the UP/DOWN scroll button to select O2 sensor from O2 Monitor
Test menu and press OK button.
Figure 4-17 Sample O2 Monitor Test Menu
If the vehicle does not support the mode, an message displays on the screen.
31
Figure 4-18 Sample Nonsupport Screen
4) View test results of selected O2 sensor.
Figure 4-19 Sample O2 Sensor List
32
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 7 Conventions
- 7 Bold Text
- 7 Notes and Important Messages
- 8 Hyperlink
- 8 Illustrations
- 9 Tool Description
- 10 Specifications
- 10 Accessories Included
- 11 Keypad
- 11 Power
- 12 Vehicle Coverage
- 13 Product Troubleshooting
- 13 Vehicle Linking Error
- 13 Operating Error
- 13 Scan tool doesn’t power up
- 16 ABS
- 17 Read Codes
- 18 Erase Codes
- 20 SRS
- 20 Read Codes
- 20 Erase Codes
- 21 Engine
- 21 Read Codes
- 21 Erase Codes
- 22 Transmission
- 22 Read Codes
- 22 Erase Codes
- 24 System Status
- 25 Read Codes
- 26 Erase Codes
- 28 Live Data
- 28 View Data
- 28 Viewing Complete List
- 30 Viewing Custom List
- 31 Record Data
- 33 Freeze Frame
- 34 Retrieving I/M Readiness Status
- 37 O2 Monitor Test
- 39 On-Board Monitor Test
- 41 Component Test
- 43 Viewing Vehicle Information
- 44 Modules Present
- 45 DTC Lookup
- 48 Review Data
- 49 Delete Data
- 50 Print Data
- 51 Language Setup
- 52 Unit of Measure
- 53 Beep Set
- 53 Key Test
- 54 LCD Test
- 56 Print Data
- 57 Software Update
- 57 Register the Tool
- 58 Update Procedure
- 59 Batch Update
- 59 Single Update
- 61 FCC Compliance
- 62 SAR
- 62 RF WARNING STATEMENT
- 62 RoHS COMPLIANCE
- 62 CE COMPLIANCE
- 63 Limited One Year Warranty
- 63 Service Procedures