8.1 BASE TO COLUMN. Draper 12 Speed Floor Standing Drill, 600W, 12 Speed Floor Standing Drill

8. ASSEMBLY

WARNING: The headstock, and consequently when fully assembled the drilling machine, are extremely heavy. Care shall be taken when manoeuvring. The use of a hoist should be employed to ensure safety.

NOTE: Remove the plug from the socket before carrying out adjustment, servicing or maintenance.

8.1 BASE TO COLUMN -

FIGS. 1 - 3

Align the column base onto the base

and secure with the four 16mm bolts

.

NOTE: Do not overtighten the bolts as this may crack the casting.

Lock column to column base with grub screw

$ .

FIG.1

FIG.2

8.2 TABLE - FIG. 4

Slot the table into the table bracket and tighten locking handle .

FIG.3

- 12 -

FIG.4

$

8. ASSEMBLY

8.3 HEADSTOCK - FIG. 5

WARNING: The headstock assembly poses a significant health and safety hazard while being lifted and positioned into place. Seek assistance.

Lift the headstock onto the top of the column. When aligned and located down onto the column fully, tighten grub screws

$ with the hex. key supplied.

NOTE: Adjust the drill head over the table and base before securing. The use of a level may be beneficial to improve accuracy.

8.4 PLUNGE HANDLES - FIG. 6

Screw plunge handles onto hub, hand tighten.

8.5 CHUCK AND ARBOR -

FIGS. 7-8

The drill chuck, arbor and headstock spindle join together with an interference fit formed by the matched tapers of the mating surfaces.

Ensure all mating surfaces are clean as any debris will cause the taper to mis-align possibly resulting in the chuck or arbor coming loose creating a potential hazard.

Using the chuck key provided open the chuck until the jaws are completely recessed and protected from damage.

Insert the short taper end of the arbor into the back of chuck . A sharp tap with a soft blow mallet will securely join them together.

NOTE: Ensure the chuck is on a surface that will not absorb the force of the mallet. If the chuck does not mate securely, repeat the process.

Insert the long taper end of arbor (P) into the spindle. Rotate the chuck assembly until the arbor locates allowing complete insertion.

Tap the chuck to securely locate it in place.

FIG.6

FIG.7

- 13 -

FIG.8

$

FIG.7b

FIG.5