Removing the Doors. LG GS-L6013PZ, GS-J6011SB, GS-X6018MT, GS-X6010MC, GS-L6012PZ, GS-X6011NS

Removing the Doors

If your entrance door is too narrow for the appliance to pass through, remove the appliance doors and pass the appliance laterally.

WARNING

• Disconnect the power cord, house fuse or circuit breaker before installing or servicing the appliance. Failure to follow these instructions may result in death, fire or electric shock.

Removing the Freezer Door

1 The water supply line is connected to the top right part in the back of the appliance.

Remove the connected water tube by pressing the collet towards the tube connector.

4

Rotate the hinge lever d counterclockwise.

Lift the top hinge e free of the hinge lever latch f

.

EN

CAUTION

• When lifting the hinge free of the latch, be careful that the door does not fall forward. It is recommended that two or more people carry out the door removal and refitting.

5 Remove the door by lifting it off the bottom hinge pin.

2 Remove the screw of the hinge cover on top of the appliance by rotating it counterclockwise.

3

Pull out the water supply line a . Disconnect all wire harnesses b . Unscrew the ground wire c .

CAUTION

• Place the door on a non-scratching surface with the inner side facing up.

Removing the Fridge Door

1 Disconnect all wire harnesses a

.

12

2

Rotate the hinge lever b clockwise. Lift the top hinge c free of the hinge lever latch d .

NOTE

• Disassembling/Assembling the water lines.

EN

CAUTION

• When lifting the hinge free of the latch, be careful that the door does not fall forward. It is recommended that two or more people carry out the door removal and refitting.

3 Remove the door by lifting it off the bottom hinge pin.

a

Collet b

Water supply line c

Insert line d

Clip

• Gently insert the water supply line until only one of the line’s insert lines is visible. Pull on the line to make sure that it is tightly fastened.

Correct

Incorrect

CAUTION

• Place the door on a non-scratching surface with the inner side facing up.

Refitting the Fridge and Freezer

Doors

Mount the doors in the reverse sequence of their removal once the appliance has been passed through all access doors.

CAUTION

• Install the right fridge door first.

• If the end of the water supply line is damaged, it should be trimmed to ensure it does not leak when refitted.

• e

Not straight f

Damaged g

Stretched

13